Meynorway WLGY-S9 3In1 Fast Wireless Charger User Manual
- June 12, 2024
- Meynorway
Table of Contents
Meynorway WLGY-S9 3In1 Fast Wireless Charger
Thank you very much for purchasing our product. We’d love to serve you at our best,at the same time we kindly advise you to read this manual in detail and maintain. It carefully for a better and longer use experience.
Product Configuration
3 in 1 wireless charger,one instruction
Structure and installation mode
Connect the wireless charging USB power cord before use.Use 9V/3A charger to
achieve the best charging effect.
Power up:Blue light on for 3 seconds.
- No load:Off.
- Phone charging:Blue light on,extinguished after full.
- Abnormal status:Blue light flicker.
Performance Parameter
- Name: 3 In 1 Wireless Charger
- Model: WLGY-S9
- Colour: Graphite Gold
- Input: SV/3A,9V/3A
- Output:
- Phone: SW/ 7.SW/ 10W/1SW(MAX)
- TWS: SW (max)
- Watch: 3W(max)
Matters Needing Attentionl
- To achieve the best charging effect, please use the 9V/3A charger.
- Connect the USB power cord to the charger before using it(no charger is included in this standard.
- The protection case of devices need to be less than 3mm,or it may affect the charging efficiency. Cases made of metal,attachments such as magnets, cards,grips will interfere with charging.
- Make sure that the mobile phone supports QI wireless charging function.
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is Subject To the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not explicitly approved by the party responsible for
compliance could void the user’s authority to operate this equipment.
Note: this equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and candidate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. During the operation of device a distance of 15 cm surrounding the device and 20 cm above the top surface of the device must be respected.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>