Aohai WX013 Wireless Charger User Manual
- June 12, 2024
- Aohai
Table of Contents
Aohai WX013 Wireless Charger User Manual
Wireless Charger
Input voltage: USBA 5VDC (4.75-5.25V) ≧ 1A
Output voltage: 5V (4.75-5.25V)
Output current: 0.7a max
Output efficiency: %80%(between coils)
Working frequency: 298-342kHz
Work temperature: -0 ℃-+35 ℃
Relators: 10%~ 80%
Product introduction:
This product is only suitable for Foxconn models. It has the characteristics of small volume, convenient carriers, wide supply power supply, simple appearance and other characteristics. Products have comprehensive and reliable temperature protection, over -pressure arrears protection, short circuit protection, and over current protection.
Operation step:
- Insert this product USBA and insert it into a charger with USBA output.
- Insert the charger and insert 110/220V to make the power supply work.
- Put the product with a silicone pad and place it on the desktop.
- Put the watch on the wireless charging and charge.
- The watch prompts charging within 5 seconds. It means that the charging connection is successful.
Note: Specify the positive and negative product. There is one side of the silicone pad, put it on the desktop, and put the watch on the other side to charging.
Charging diagram
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment. This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>