THE HOME DEPOT PeerBasics Corner Tool Storage Rack Instruction Manual

THE HOME DEPOT PeerBasics Corner Tool Storage Rack

Features

• STORES MORE THAN 40 TOOLS
• WALL MOUNT DR STANDALONE
• UNIOUE PEGBOARD DESIGN
• EASY ASSEMBLY
• MODULAR CONNECTORS
• DURABLE PLASTIC WON’T RUST DR ROT

A READ BEFORE INSTALLING

• Beware at overloading. While the comer rock con stund alone without being wall mo1H1ted it is high/V recommended to secure the comer rock to a wall bV screwing in the rock at its muHip/e hanging positions. Different tools weigh different omo1H1ts and overloading or not securing mov cause the svstem to tip and toll.
• Beware at the balance at the corner rock. Placing too monv tools on one side or too much weight on one side mov cause the comer rock ID tip. For best reso/ts screw in the comer rock to the wall to prevent tipping or tolling.
• AIWovs mo/ce sure screw installation points ore along stud or ore proper/V secured, using the wall plugs, to the wall it is being instulled on. Consult on exPerienced honl/Vmon or contractor tor best results.

ASSEMBLY

• Place base dawn an a flat surface.
• Insert the three (3) structures inside the hose. Make sure to match the structure profile to the hose profile port.
• No tools are necessarv. but a robber mallet can be used ta make sure the structures are inserted tu/Iv.
• Place tap panel an structural pieces sa thev light/V tit inside the tap panels receiving hales.
• Slighttv push each side into the structure until thev·re oil firmtv inserted.
• The structure is now complete.
• If the set is flimsy or rocks from side-to-side check to make sure the structures ore futtv are inserted into the hose and top panel.
• It is high/V recommended ta use the included screws and wall plugs ta tie the rack ta the wall tar added support.

lnterlocking svstem

NOTE : ONE SET PER BOX. 3 Ii 4 require two or mare sets.

1. Align the male li female connectors at 2 ar mare sets.
2. Single set. In Carner.
3. Two sets combined, along wall.
4. Faur sets combined, freestanding.

Wall Haunting

1. Set the rack into position.
   Mark desired drill location in the openings on the underside of the top panel. There are a total of eight locations to mark. The more tie back screws installed the more secure the rack.
   Wall plugs are also provided for different wall constructions.
   Move the rack awav from the position.

2. Drill the screws into marked position. Leave gap of 1/8″ between wall.

3. Lift the rack back into the desired location. Dropping it into place aver the inserted screws.

4. Tighten the screws once the rack is in position. Becareful not ta aver tighten as it may crack the rack material.

Pegboard system

1. Insert two prong side into the pegboard at an angle, pictured.
2. Rotate the hook dawn until it rests in place.
   DD NOT OVERLOAD HOOKS, OVERLOADING CAN CAUSE DEFORMATION OF THE PEGBOARD.

www.PeerBasics.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>