ALPHAFIT MKT1026 Stall Wall Pair Instruction Manual
- June 12, 2024
- ALPHAFIT
Table of Contents
RIG MOUNTED
GYMNASTICS WALL
ASSEMBLY GUIDE
IMPORTANT – READ FIRST
Resistance training, gymnastics training and activities at height are
potentially dangerous and may lead to severe injury or even death. This
equipment must only be used by competent and responsible persons, or under the
direct and visual control of a competent and responsible person.
Use common sense when training, obtain instruction to ensure safe execution of
movements.
Obtaining instruction in appropriate techniques and methods of use is your own
responsibility. You assume all risks and responsibilities for all damage
injury or death which may occur during or following incorrect use of this
equipment in any matter whatsoever. AlphaFit bears no liability beyond the
replacement value of the equipment in question.
It is the responsibility of the owner to ensure that all users of this product
are adequately informed of all precautions. The safety and integrity designed
into the equipment can only be maintained when it is regularly examined for
damage and repaired. It is the responsibility of the user/owner to ensure that
regular maintenance is performed. Inspect and properly tighten all parts
regularly. Replace any worn or damaged parts immediately and do not use until
the equipment has been repaired.
Both AlphaFit and buyer disclaim any express or implied warranty, including,
without limitation, warranties or merchantability and/or fitness for a
particular purpose with respect to the equipment.
WARNING: MISUSE OF THIS EQUIPMENT CAN RESULT IN SEVERE INJURY OR DEATH.
BUYER ASSUMES ALL LIABILITY IN USAGE OF EQUIPMENT. DOCUMNET NO: MKT1026
COMPONENT OVERVIEW
GYMNASTICS WALL PART LIST:
Read this entire guide before attempting to build or use this machine. This
guide contains step by step instructions for proper assembly.
AlphaFit recommends a minimum of two (2) people to assemble the Gymnastics
Wall.
Use the parts list included in this guide to verify that all parts are
accounted for before assembly. If any parts are missing, contact AlphaFit on
1300 257 428 or admin@alphafit.com.au.
GYMNASTICS WALL ASSEMBLY
STEP 1: REMOVE PULL UP BAR AND ATTACH CROSSBEAM
Unbolt and remove the pull up bar from the rig cell. Bolt crossbeam brace to
top of uprights. Letters denote appropriate fasteners.
GYMNASTICS WALL ASSEMBLY
STEP 2: ATTACH STALL WALL FRAMES
Bolt the two stall wall frames to uprights as illustrated below. Letters
denote appropriate fasteners.
STEP 3: ATTACH CHIN UP BAR
Bolt chin up bar to front of crossbeam brace. Letters denote appropriate
fasteners.
For additional information, contact AlphaFit:
**** 1300 257 428
admin@alphafit.com.au
www.alphafit.com.au
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>