Shirry Group P205 Wheel Cover Installation Guide
- June 12, 2024
- Shirry Group
Table of Contents
Shirry Group P205 Wheel Cover
Installation Guide
Caution: Always use personal protective equipments while installing or removing any wheel covers.
Step 1: Determine size of wheel cover
Find a series of 9 letters and numbers on the side of your tire that begins
with the letter “P”. At the end of this series, you will see the letter “R”
followed by 2 numbers.
These last two numbers are your wheel cover size. For example, a tire that has
the following letters and numbers P205/5516 will require 16″ hubcaps.
Step 2: Install retention ring on the wheel cover
Locate the indent in the retention ring and the notch of the wheel cover. The
indent on the retention ring should be aligned with the notch of the wheel
cover. The indent should point towards the hubcap. Install retention ring in
the upper groove of the hubcap.
-
Indent direction
Towards hubcap -
Upper groove
Normal fit
Step 3: Install the wheel cover on the steel rims
Remove old wheel cover and clean steel rims. Locate the tire valve stem and
the notch of the wheel cover. The notch on the wheel cover should be aligned
with the tire valve stem. Gently start pushing and tapping the wheel cover
onto the steel rims until it snaps into place.
- Locate valve stem to align it with notch
- Snap onto the rim by gently tapping and pushing
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>