HOMELYLIFE 8025B Dinosaur Baja Racer Remote Control Cars Instruction Manual

HOMELYLIFE 8025B Dinosaur Baja Racer Remote Control Cars

Content

Please read the instructions carefully before operating the toy.
Please keep this instruction sheet for future reference.

Prepare

1. Tear off the sticker, open the transparent cover in the direction of the arrow.
2. As shown. use a phillips screwdriver to unscrew the screws between controller and car with the direction of the arrow, take out the car with the base.
3. Use a phillips screwdriver unscrew the screws at the bottom of the car by the direction of the arrow, remove the race car.
4. Open the battery cover and insert 2°AA batteries with correct polarity “The remote control can only use alkaline batteries. Do not use other types of batteries.
5. Press any button and the indicator light is on, this prove that the battery installed correcty.

Charge

1. As shown in the figure, tum on the battery cover, take out the charge plug.

2. Insert the charging plug into the charging port under the car, the indicator light is on, indicating that it is charging.
   Notice:
   The car can be charged only when the switch of car in the OFF position.

3. When the charging light goes off, The mini racer is fully charged.

Operate

1. Remote control button functions:
2. After pressing the remote control button, the indicator light will light up, and the car will act accordingly.
3. When pressing the forward/backward button, the car can go forward/backward.
4. When pressing the forward/backward
5. Adjust the trimmer on the bottom front of the car to adjust the straight-line performance of the car.

Caution:

• a). The car itself uses 1.2V 1/4AAA NI-MH rechargeable built-in battery, the remote control uses 2*1.5V A batteries (not included);

• b). The racing car has super power. When driving at high speed, it cannot brake suddenly due to inertia. Please specially pay attention when in use.

• c). If the car slows down obviously during running, it may be due to lack of power, please charge the car following the instruction.

• d). When the battery of the remote control is dead, the indicator light turns dim. The car cannot be charged, please replace the new battery for remote control.

• e). Pay attention to the charging plug and charging position when charging.

• f). When not in use for a long time, please take out the battery of the controller and turn the power of the racing switch to “OFF” location.

• g). Non-rechargeable batteries shall not be charged. Rechargeable batteries should only be charged under adult supervision.

• h). New and old batteries or different types of batteries must not be mixed.

• i). The rechargeable battery should be removed from the toy before charging.
  Exhausted batteries should be removed from the toy;

• J). Batteries should be inserted with correct polarity to avoid installation errors.

• k). The supply terminals are not to be short-circuited.

• 1). Unpack under adult supervision.

• m). Please keep the above information for future reference.

FCC STATEMENT

FCC Compliance Statements
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a B Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. S However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>