ARIA Flush Device Mount Installation Guide
- June 12, 2024
- Aria
Table of Contents
ARIA Flush Device Mount Installation Guide
Device Installation
-
Shut off circuit breaker and disconnect existing device from wall.
-
Using dotted line on instruction guide, cut hole to allow Mount to be inserted.
-
Optional : Use Smash Plate as guide, secure to wall using pins as a stamp.
-
Feed wires through pre-drilled hole and place the Mount in the cavity
-
Use drywall compund mud to cover flange. Once dry, sand. Repeat as needed.
-
Paint to match surface
-
Attach the unit to the Mount in the same manner as you would to drywall
-
Connect device, turn on power and enjoy!
Pot Light Installation
-
Drill hole in Mount according to the dimensions of the pot-light being used
-
Secure Smash Plate to ceiling frame prior to drywall using nails or wood screws.
-
Note the location of the cutout before installing the drywall. Install drywall and cut using the Smash Plate as a guide.
-
Disconnect power and feed wires through ceiling and Mount
-
Secure Mount using staples or drywall screws.
-
Use drywall compund mud to cover flange. Enjoy!
-
Connect wires and place components through hole. Individual pot-light install may vary
-
Enjoy!
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>