OYJFAX TOPR-000270 2.4GHz Frequency Remote Control for RC Tractor Farmer Instruction Manual
- June 12, 2024
- OYJFAX
Table of Contents
TOPR-000270 2.4GHz Frequency Remote Control for RC Tractor Farmer
Instruction Manual
FREQUENCY PAIRING
This product uses 2.4GHz frequency remote control.
before the play, should be on the remote control and the vehicle frequency
matching.
Tractor and remote control after installing the battery power is trned on.
| Tractor power switch | Remote power switch |
|---|---|
At this point the remote control will automatically find the frequency, light
is blinking. When the remote control light stops flashing.
Frequency matching is completed, the remote control function can be used
normally.
OPERATION OF REMOTE CONTROL
- Switch
- Forward/Backward
- Turn left/Turn right
- Olight
- Auto demo
TRACTOR BATTERY ILLUSTRATE
- Connection LED lights lit;
- Charging LED lights flast slowly;
- Full LED light goes out.
| |
---|---|---
Mode 1
Connected to the computer USB charing.| Mode 2
Connect the USB adapter charge.| Mode 3
Charging a mobile charging treasure.
CONTROLLER BATTERY ILLUSTRATE
BATTERY WARNING
- Non-rechargeable batteries are not to be recharged;
- Rechargeable batteries are only to be charged under adult supervision;
- Rechargeable batteries are to be removed from the toy before being charged;
- Different types of batteries or new and used batteries are not to be mixed;
- Batteries are to be inserted with the correct polarity;
- Exhausted batteries are to be removed from the toy;
- The supply terminals are not to be short-circuited.
- Batteries are only be charged by persons at least 8 years old.
- Do not mix old and new batteries.
- Do not mix alkaline batteries,standard(carbon-zinc) or rechargeable.
Keep this package for reference since it contains important information.
FCC Caution:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>