VINUOVO 116-038 Glass Garden Fences and Posts Instruction Manual
- June 12, 2024
- VINUOVO
Table of Contents
VINUOVO 116-038 Glass Garden Fences and Posts
Product Information: – Product Name: Glass Garden Fences and Posts –
Available Sizes: – Glass Fence Panel: 1000 mm, 1500 mm, 1500/1000 mm – Multi
Post: 50/90 x 50/90 x 1084 mm, 50/90 x 50/90 x 1580 mm – Included Components:
– Ax1, Bx1, BB x 1, C x 1, D x 1, E
x 4, M3.5x12mm screws, H x 1
Product Usage Instructions:
Start by raising the glass fence. Ensure that the end with the pre-drilled
holes in the aluminum list faces up. 2. Place the glass fence between two
multi posts and drill two holes on both sides of the multi post using the
provided drill, through the pre-drilled holes in the aluminum list. 3. Fasten
the glass fence using the four screws provided. 4. Now place the fence on the
surface and ensure it is level. Mark the four holes in the foot of the post
onto the surface. 5. Repeat the above steps for the next section, following
the same procedure until the entire fence is completed.
Recommended Wind Guidelines: –
Glass Fence 100 cm: – Wind Gust: 19 m/s, 20 m/s, 21 m/s, 22 m/s, 23 m/s – Glass Fence 150 cm: – Wind Gust: 15 m/s, 16 m/s, 17 m/s, 18 m/s, 19 m/s Please note that these guidelines are based on a controlled wind test. For any further assistance or inquiries, please refer to the product manual or contact our customer support.
Installation instructions for glass garden fences and posts
Congratulations on your new glass garden fence.
For a glass fence with a height of 100 cm, a multi-post of 108 cm height must be purchased. For a glass fence with one height of 150 cm, a multi-post of 158 cm height must be purchased. Mounting screws/bolts Ø8 mm to be purchased separately, as these vary according to which material to fix the posts. The multi post has 2 groove covers that can be removed as needed, thus the post can be used as an end, middle or corner post. Each glass fence comes with 4 screws and 1 drill bit. ATTENTION! The glass panels are tempered safety glass and are suitable for installations where the height of fall is less than 50 cm.
Setting up fences and posts
- Start by raising the glass fence. The end with the pre-drilled holes in the aluminium list must face up.
- Place the glass fence between 2 multi posts and drill 2 holes in both sides of the multi post with the provided drill, trough the pre-drilled holes in aluminum list.
- Fasten the glass fence with the 4 screws provided.
- Now place the fence on the surface. Make sure it is in level. Mark the 4 holes in the foot of the post into the surface.
- Move the fence and drill 4 x Ø8 mm holes into the surface. Fasten the fence to the ground and continue with the next section following the same procedure until the entire fence is completed.
Guidelines – based on controlled wind test
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>