winways Art-100 Rollable Fresnel Screen User Manual
- June 12, 2024
- winways
Table of Contents
winways Art-100 Rollable Fresnel Screen
For Short/Long Throw Ratio Projectors
- Tools Required:
- Level ruler
- Tape measure (measurable length 3 meters)
- Pencil
- Clean gloves
- Wall Status Required:
- Installation interface is clean, free of dust and dirt.
- The painted wall must not fall off powder and can be adhered closely to the double-sided tape.
- The installation interface requires a smooth surface without abnormal bumps, the wall flatness differences across the screen installation area must be less than 3mm.
- Note:
- When sticking the magnetic components, it is recommended to stick it from up to down and use a scraper to compact to avoid air bubbles.
- Recommend 2 persons when lifting the screen to apply it to the rubber magnet on the wall.
- Parts List:
- 100 Screen 1EA
- User Manual 1EA
- Rubber Magnet 8EA
- Gloves 2EA
- Dust-Free Cloth 1EA
- Pendant 2EA
- Pendant Sticker 2EA
- Hanging Wire 1EA
Front Projection-Installation Guide
- Turn on projector, confirm installation area
- Confirm, mark the centerline of the diasrpelay, fix pedant 1112mm away from centerline mark the bottom line and top line.
- Show Art-100 Cal. Picture* oPnrtohjeecwtoarll
- Stick rubber magnets onto the blue blocks of Art-100 Cal. Picture
- Paste pendants along the vertical line and Point A3, A4.
- Lift the screen onto the wall, along with vertical, horizontal lines, and the 2 pendants.
- Take away the 2 pendants, installation job DONE!
- Use your projector to check if the image covers all the screen.
Front/Ceiling Projection:
Art-100 is required to be reversed installed (upside down), please note
that under this circumstance, Art-100 rejects ambient light from below, left
and right, rather than above, left and right in front projection
circumstances.
*Art-100 cal. picture: please download Art-100 calibration picture from our website, or ask local distributor for it.
For more information or technical support, please visit:
www.winways.com.au
Winways Rollable Fresnel Screen Art- 100
For Short/Long Throw Ratio Projectors
Tools Required
Level ruler, tape measure (measurable length≥3 meters), pencil , when installing this product , the operator needs to wear clean gloves .
Wall Status Required
Installation interface is clean , free of dust and dirt . The painted wall must not fall off powder and can be adhered closely to the double-sided tape . The installation interface requires a smooth surface without abnormal bumps , the wall flatness differences across the screen installation area must be less than 3mm .
Note: When sticking the magnetic components , it is recommended to stick it from up to down , and use a scraper to compact to avoid air bubbles . Recommend 2 persons when lifting the screen to apply it to the rubber magnet on the wall .
Parts List
Front Projection-Installation Guide
Front/Ceiling Projection: Art- 100 is required to be reversed installed(upside down) , please note that under this circumstances , Art- 100 rejects ambient light from below, left and right , rather than above , left and right in front projection circumstances .
- Art- 100 cal. picture: please downloadArt- 100 calibration picture from our website, or ask local distributor for it
For more information or technical support , please visit: www.winways.com.au
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>