hansgrohe FOCUS E2 Valve Faucets Instruction Manual
- June 12, 2024
- hansgrohe
Table of Contents
hansgrohe FOCUS E2 Valve Faucets
Product Information
The product is a Hansgrohe mixer for hot and cold water. It can be used with hydraulically and thermally controlled continuous flow heaters. The mixer has a maximum operating pressure of 1 MPa and a recommended operating pressure of 0.1-0.5 MPa. The test pressure is 1.6 MPa and the recommended hot water temperature is determined by the flow rate, which is 11 liters per minute at 0.3 MPa. The mixer has a hot water limiter that can be adjusted using instructions provided on page 21 of the manual. The mixer also includes spare parts, operation instructions, and cleaning instructions.
Product Usage Instructions
Safety Notes:
Wear gloves during installation to prevent crushing and cutting injuries. The
hot and cold supplies must be of equal pressure.
Assembly Instructions:
Refer to page 17 of the manual for assembly instructions.
Adjusting the Hot Water Limiter: To adjust the
hot water limiter on single lever mixers, please see page 21 of the
manual.
Technical Data:
The mixer has a maximum operating pressure of 1 MPa and a recommended
operating pressure of 0.1-0.5 MPa. The test pressure is 1.6 MPa and the
recommended hot water temperature is determined by the flow rate, which is 11
liters per minute at 0.3 MPa.
Cleaning Instructions:
Refer to the enclosed brochure for cleaning instructions.
Spare Parts:
Refer to page 19 of the manual for spare parts information.
Do Not Use Silicone Containing Acetic Acid:
Do not use silicone-containing acetic acid with the mixer.
Models
Safety Notes
- Gloves should be worn during installation to prevent crushing and cutting injuries.
- The hot and cold supplies must be of equal pressures.
Installation Instructions
- The fitting must be installed, flushed and tested after the valid norms!
Technical Data
- Operating pressure: max. 1 MPa
- Recommended operating pressure: 0,1 – 0,5 MPa
- Test pressure: 1,6 MPa (1 MPa = 10 bar = 147 PSI)
- Hot water temperature: max. 80°C
- Recommended hot water temp.: 65°C
- Rate of flow by 0,3 MPa: 11 l/min
Hansgrohe mixers can be used together with hydraulically and thermally controlled continuous flow heaters if the flow pressure is at least 0,15 MPa.
- To adjust the hot water limiter on single lever mixers. No adjustment is necessary when using a continuous-flow water heater.
- Do not use silicone-containing acetic acid!
Assembly
Dimensions
Spare parts
Operation
Open
Close
Hot
Cold
Open
Close
Cleaning
see the enclosed brochure.
Hansgrohe
Postfach 1145 · D-77761 Schiltach · Telefon +49 (0) 78 36/51-1282 · Telefax
+49 (0) 7836/511440
E-Mail: info@hansgrohe.com. Internet:
www.hansgrohe.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>