LDSBus HVT-Junction IoTPortal User Guide
- June 12, 2024
- LDSBus
Table of Contents
LDSBus HVT-Junction IoTPortal
LDSBus HVT-Junction
The LDSBus HVT-Junction is a device that connects LDSBus Devices (Sensors/Actuators) to the LDSBus. Each junction can connect up to four LDSBus Devices, and additional LDSBus HVT-Junctions may be daisy chained to add more LDSBus Devices to the LDS Bus.
Setup Instructions
Follow the below instructions to set up the LDSBus HVT-Junction
- Connect the first LDSBus HVT-Junction to any of the LDSBus Host Systems using an RJ45 (CAT5e) cable.
- Connect the configured LDSBus Device(s) to the LDSBus HVT-Junction as shown.
- If there is more than one LDSBus HVT junction in the system, chain them together as shown.
Note: Enable termination for the last LDSBus Device in the bus.
For additional information on the LDSBus HVT-Junction, application setup, and installation, please scan QR code A or visit https://brtsys.com/resources/. To register for warranty, please scan QR code B or visit https://brtsys.com/warranty using the UUID and Product Key found in the Sticker Area.View the full information on the LDSBus HVT-Junction, application setup and installation at https://brtsys.com/resources/ or scan QR Code B.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>