Winado 195408160231 132 Gal. Green Collapsible Rain Barrel Instruction Manual
- October 30, 2023
- Winado
Table of Contents
COLLAPSIBLE RAIN BARREL
ASSEMBLY INSTRUCTION
Warning
The barrel is” sit still” design, any inappropriate pull or drag may cause
product damage.
Please place the barrel on the even ground.
Don’t move the barrel while it is full of water.
Keep children out while in use.
PARTS LIST
ASSEMBLY STEPS
Step 1 – Assemble Bottom Drain Spigot
Wrap the screw thread of Part D with Part I PTFE thread seal tape.
Insert the spigot into the BOTTOM hole of the rain barrel.
Make sure one rubber washer is outside of the rain barrel, the other one is
inside.
Adjust the spigot to a right direction.
Step 2 – Assemble Top Overflow Valve
Insert the valve into the TOP hole of the rain barrel as instruction.
Make sure one rubber washer is outside of the rain barrel, the other one is
inside.
Step 3 – Assemble the White Spigot
Follow step 1 to wrap the screw thread of Part H with Part I PTFE thread seal
tape.
Insert the white spigot into the MIDDLE hole of the rain barrel.
Make sure one rubber washers is outside of the rain barrel, and the other one
is inside.
Adjust the spigot to a right direction.
If you find the spigot is leaking, firstly pls double check if your parts were assembled correctly or not; secondly try to rewrap the PEFE thread seal tape; if it’s still leaking, pls contact us for help.
Step 4 – Assemble the Rain Barrel Frame
Insert all the poles into the slot openings on the bottom of the rain barrel.