LiveCare Link+ 4G Smart Home Gateway User Guide
- June 4, 2024
- LiveCare
Table of Contents
Link+
User Guide
Setup the Link+
Step 1: Set Up the Charging Dock
To set up your charging dock, connect the charging cable, and adapter to a
power or wall outlet.
Step 2: Power On Link+
Next, plug the Link+ into the charging dock. The Link+ will automatically
power on, and the LiveCare logo will appear on the screen. (This process could
take up to 2 minutes)
Note: Always leave the Link+ on the charging dock
Step 3: Accept Terms and Conditions
Once the Link+ powers on, please accept the LiveCare Terms and Conditions and
RPM Consent Form.
Step 4: Your Link+ is Ready!
Your Link+ is set up and ready to take your vital signs.
How to take blood pressure
Step 1: Connect Blood Pressure Cuff
Insert the connector with cuff tube into the air socket located on the left
side of the blood pressure monitor. (see picture)
Step 2: Wrap the cuff around your arm
Rest your left arm flat on the table or arm of a chair. Make sure the cuff is
at a heart level with your heart.
Step 3: Press the “Start” button
Press the “Start” button, and the Blood Pressure Monitor will begin to take
your blood pressure. Once it has finished, it will automatically send your
information via Link+.
How to take Pulse
Step 1: Press the “Start” button
Place the Pulse Oximeter on the finger. (See Proper Usage Recommendations)
Press the “Start” button, and the Pulse Oximeter will begin to take your
pulse. Once it has finished, it will automatically send your information via
Link+.
Step 2: Remove Pulse Oximeter from finger
Once complete, remove Pulse Oximeter from your finger. The Pulse Oximeter will
automatically power off after 5 seconds.
Emergency Response Feature
Step 1: Press the red emergency button
On the Link+ device, press the red emergency button and hold for 2 seconds to
call for help.
Step 2: Confirmation screen
After holding down the emergency button you will see a confirmation screen
asking if you have an emergency. If the request did not go through, you will
see a screen prompting you to call 911. See below.
Proper Usage Recommendations
**** Proper usage of your Blood Pressure Monitor and Pulse Oximeter is very important for taking accurate vitals
Blood Pressure Monitor
- Don’t eat or drink anything in the half hour before you take your blood pressure.
- Sit in a comfortable chair with your back supported for at least 5 minutes before your reading.
- Make sure the blood pressure cuff is snug but not too tight. The cuff should be against your bare skin, or over thin clothing.
Pulse Oximeter
- Try not to move when taking the pulse oxygen to prevent abnormal readings.
- Place Pulse Oximeter on the middle finger or ring finger for the most accurate reading.
- Make sure your hands are not too hot or cold before taking a reading.
Improving Aging in Place
252 W 37th Street, 17th Floor, New York, NY 10018
P:800-993-4233
E:info@livecareusa.com
www.livecareusa.com
Documents / Resources
|
LiveCare Link+ 4G Smart Home
Gateway
[pdf] User Guide
Link, 4G Smart Home Gateway, Smart Home Gateway, Home Gateway, Link, Gateway
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>