hansgrohe Ecostat E Thermostat Instruction Manual
- October 30, 2023
- hansgrohe
Table of Contents
- hansgrohe Ecostat E Thermostat Instruction Manual
- Safety Notes
- Installation Instructions
- Technical Data
- Symbol description
- Adjustment (see page 63)
- Maintenance (see page 64)
- Dimensions (see page 66)
- Read More About This Manual & Download PDF:
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
hansgrohe Ecostat E Thermostat Instruction Manual
Safety Notes
Gloves should be worn during installation to prevent crushing and cutting
injuries.
The shower system may only be used for bathing, hygienic and body cleansing
purposes.
Children as well as adults with physical, mental and/ or sensoric impairments
must not use this shower system without proper supervision. Persons under\ the
influence of alcohol or drugs are prohibited from using this shower system.
The hot and cold supplies must be of equal pressures
Installation Instructions
The fitting must be installed, flushed and tested after the valid norms!
Technical Data
Operating pressure: max. 1 MPa
Recommended operating pressure: 0,1 – 0,5MPa
Test pressure: 1,6MPa (1 MPa = 10 bar = 147 PSI)
Hot water temperature: max. 80°C
Recommended hot water temp.: 65°C
Rate of flow by 0,3 MPa: approx. 26 l/min anti-pollution function
Symbol description
Do not use silicone containing acetic acid!
Safety Function (see page 62)
The desired maximum temperature for example max. 42º C can be pre-set thanks
to the safety function.
Adjustment (see page 63)
After the installation, the output temperature of the thermostat must be
checked. A correction is necessary if the temperature
measured at the output differs from the temperature set on the thermostat.
Maintenance (see page 64)
To guarantee the smooth running of the thermostat, it is necessary from time
to time to turn the thermostat from total hot to total cold.
The mixer is equipped with non return valves. The non return valves must be
checked regularly according to DIN
EN 1717 in accordance with national or regional regulations (at least once a
year). At this time, please also check the
filter (A) situated on the MTC-thermoelement (94282000). After assembling the
MTC-thermoelement, it is necessary to check the water temperature at the take
off point as described under the headline adjustment“. Before the adjustment,
please check, if the warm water supply is activated and the maximum
temperature of the warm water is available at the take off point.
Dimensions (see page 66)
Spare parts (see page 67)
XXX = Colors 000 chrome plated 090 chrome plated/gold plated 400 white/chrome
plated 880 satin chrome
Operation (see page 68)
Cleaning
see enclosed brochure
Test certificate (see page 66)
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>