Solux 600099 Dreamcatcher LED System Instructions

INSTRUCTIONS
INSTRUCCIONES

600099 Dreamcatcher LED System

Thank you for purchasing the Dreamcatcher 720w Led Lighting Fixture To achieve the best results from your product, please follow these instructions for assembly and operation.
Contents: Ref. 600099
Dreamcatcher 720w Led Lighting Fixture
2 x Ballast Mounting Brackets Bracket fixings
– 4 x Bracket Fixing Bolts
– 4 x Thumb nut
– 4 x Bolt – ballast fixing
– 4 x Hexagon nut
4 x Fixture Hanging Eyebolts

Product Details:

Safety & Maintenance:

Failure to observe the following safety warnings may result in injury. Additionally, product warranties will be voided if these maintenance and safety precautions are not followed.

• Keep fixture and plugs away from wet areas
• Do not overload power points
• Allow fixture to cool before performing maintenance
• Always isolate from the mains before performing maintenance
• Ensure all electrical connections are securely inserted before turning the fixture on
• Do not attempt to open, rewire or reconfigure this fixture
• Try not to touch the diodes with your fingers, as any dirt or grease will affect performance
• Do not use abrasive cleaning products on this fixture
• If needed, use a soft, slightly damp cloth to clean the diodes and then allow to dry thoroughly
• Do not use the power lead if the cable or plug are damaged in any way – obtain a replacement

Prior to Installation:

Remove the product from its packaging and check its integrity. Ensure that the fixture does not present damage or deformation.
If fixture shows signs of damage, contact the retailer. If you are satisfied with the integrity of the product, proceed to installation.

Installation:

The ballast may be positioned remotely (up to 10 metres from LED Fixture) Extension/ Link Lead(s).
This gives three advantages:

• Any heat output from the ballast is not fed into the growing environment
• The ballast, and thus the LED Fixture, may be controlled without entering the growing environment
• The ballast may be positioned in ambient temperature and humidity more conducive to its longevity To ensure ignition using this arrangement, the leads used must be of the appropriate rating (ref table below).

Technical Specifications:

(613106)
Max Ignition Distancefrom Ballast| 10m
Thermal Management| Passive
Lifetime| L90:> 50,000 hr
IP Rating| IP65
Mounting Height| Minimum 15 cm above canopy

NOTE: Full power may be too inten e for some plants at this distance
Spectrum Graph:

Compliance: This product is ERP compliant, and complies with all relevant and current EU and UK Regulations and Legislation.
Warranty: SOIHX guarantees this product free from defects in materials and workmanship for a period of 3 threeyears from point of purchase. You will void this warranty if the unit is not used in accordance to these instructions, if the unit is not used with the correct voltage, is tampered with or modified in any way or you do not have proof of purchase. Please return your purchase back to retailer with proof of purchase and original packaging. This warranty does not affect your statutory rights.
Disposal: This marking indicates that this product should not be disposed with other household wastes throughout the EU and UK. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmentally safe recycling.

Recommended Ballast: electronic Ballasts 600 w Solux (613106) (not included)
Only connect to SOiUX (613106)600 W Electronic Ballast (Never connect directly to mains Input).

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>