HUNGFA AP201-F 2 Keys Remote Control Owner’s Manual

HUNGFA AP201-F 2 Keys Remote Control

Specification

Instructions For Use

1. Remote Control Code Matching Function:
   After the receiver is powered on, press the K1 (KEY) code matching button, and then press any key on the remote control to match the code. The single-chip microcomputer automatically assigns the corresponding pin output after receiving the signal, and the indicator light flashes 3 times to indicate a successful code match. Press the left key on the remote control to output OUT1, and press the right key on the remote control to output OUT2.

2. Code Clearing Function:
   After the receiver is powered on, press and hold the code matching button for 10 seconds to clear the remote control information. The indicator light will change from constant to off.

3. Power-On Code Matching Function:
   After the receiver is powered on, the code matching window is automatically opened, and the window opening time is 15 seconds. Within these 15 seconds, press any key on the remote control for 5 seconds to match the code successfully. The indicator light flashes 3 times to indicate a successful code match and immediately exits the code matching mode. If the system does not receive a remote control signal within 15 seconds of entering the code matching mode, it will automatically exit the code matching mode.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause hannful intetference, and (2) this device must accept any intetf erence received, including intetference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful intetference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause hannful intetference to radio communications. However, there is no guarantee that intetference will not occur in a particular installation. If this equipment does cause hannful intetference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the intetference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

RF wmningfor Portable device:The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>