i-PRO WV-QDC507C Dome Cover Instruction Manual

: June 10, 2024
: i-PRO

Table of Contents

WV-QDC507C Dome Cover
Preface
Specifications
Precautions
Standard Accessories
Documents / Resources
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)

Operating Instructions
Included Installation Instructions
Dome Cover
Model No. WV-QDC507C

WV-QDC507C Dome Cover

Before attempting to connect or install this product, please read these instructions carefully and save this manual for future use.
The external appearance and other parts shown in this manual may differ from the actual product within the scope that will not interfere with normal use due to improvement of the product.
Read also the installation guide of the camera to be used.

i-PRO Co., Ltd. assumes no responsibility for injuries or property damage resulting from failures arising out of improper installation or operation inconsistent with this documentation. “<Control No.: C**>” used in these documents should be used to search for information on our technical information website ( https://i-pro.com/global/en/surveillance/trainingsupport/support/technical- information** ) and will guide you to the right information.

Preface

This product is the clear type dome cover.
The latest information about the supported cameras

Specifications

Ambient operating temperature:	–50 °C to +60 °C {–58 °F to 140 °F}
Dimensions:	77 mm (W) × 24 mm (H) x 77 mm (D) {3-1/32 inches (W) x 15/16

inches (H) x 3-1/32 inches (D)} (Dome diameter 35 mm {1-3/8 inches})
Mass:| Approx. 20 g {0.04 lbs}
Finish:| PC resin, Clear

Caution:

Before attempting to connect or operate this product, please read these instructions carefully.

Precautions

Do not use this product except with suitable cameras.
Failure to observe this may cause a drop resulting in injury or accidents.
Refer installation work or dome cover replacement to the dealer.
Installation work requires technique and experiences.
Failure to observe this may cause fire, electric shock, injury, or damage to the product.
Be sure to consult the dealer.
The screws and bolts must be tightened to the specified torque.
Failure to observe this may cause a drop resulting in injury or accidents.
When using this product, also read the “Precautions” described in the operating instructions for the camera to be attached.

Standard Accessories

Operating Instructions (this document) ………1 pc. Waterproof rubber …………………………………1 pc.
Installation
Step 1

i PRO WV QDC507C Dome Cover - Standard Accessories

Step 2

i PRO WV QDC507C Dome Cover - Standard Accessories 1

Note:

Opening the SD cover separates the camera from the enclosure.
Note that lifting the camera may cause the lens to fall off from the camera.

Replace the dome cover
Step 3

i PRO WV QDC507C Dome Cover - Standard Accessories2

Recommended tightening torque: 1.38 N·m {1.02 lbf·ft}
Be sure to replace the waterproof rubber with a new one from the accessories.
Note:
When installing this unit, remove the protective sheet once, and attach it again to the surface of the dome cover after installation is complete.
The lead wire from the IR LED is fixed with a cable tie to the protrusion of the dome plate
(★ portion). Be careful not to break off the lead wire when replacing the dome cover. (In the illustration above, the lead wires are omitted for convenience of explanation.)

i PRO WV QDC507C Dome Cover - Standard Accessories3