Outsunny 846-074 Gas Grill BBQ Barbecue Trolley Foldable With 2 Burners Instruction Manual

Gas Grill BBQ Barbecue Trolley Foldable With 2 Burners
Instruction Manual

INb1a014_GL
846-074

IGNITION INSTRUCTIONS

1. Read the safety instructions before lighting the grill.
2. Set all the knobs to the „OFF” position and connect the gas cylinder to the grill.
3. Open the lid of the grill before trying lighting the burners.
4. Open the gas cylinder.
5. Press the control knob and, while keeping it pressed, turn it up to the position „ ” counterclockwise. Press now the ignition knob. You will hear a click, which indicates the lighting.
6. Should the burner not light, close the knobs, wait ca. 5 minutes and try again.
7. Repeat steps 5 & 6 for the other burners.
8. To turn off the burners, turn back the knobs to the position „OFF”.

DELIVERED ITEMS

CONDITIONS OF USE

APPLIANCE CATEGORY| GAS AND SUPPLY PRESSURE| TOTAL NOMINAL HEAT INPUTS (HS)
---|---|---
I3B/P(50)| Butane/Propane 50mbar| 10200Btu/h 218g/h
I3B/P(30)| Butane/Propane 30mbar| 10200Btu/h 218g/h
I3+(28-30/37)| Butane/Propane 28-30/37mbar| 10200Btu/h 218g/h

ASSEMBLY INSTRUCTIONS

SAFETY INSTRUCTIONS

• Only use outdoors.
• Read the safety warnings and instructions before using this product.
• WARNING: Accessible parts can be extremely hot – keep small children away from the appliance.
• Keep this appliance away from flammable materials when using.
• Do not move the appliance when using.
• Turn off the gas supply at the cylinder after use.
• Do not modify the appliance.
• Before using, read this manual and its safety instructions carefully. Failure to follow the instructions could result in serious injury or death.
• Pay extra attention when assembling the grill to ensure it is done correctly. Always follow the instructions – only use after the grill is fully assembled.
• Place the grill on a flat and solid surface before using.
• Only use approved gas bottles for this grill (as stated in the assembly instructions).
• Only use pressure regulators and hoses that are approved for LP Gas at the stated pressures. The life expectancy of a regulator is approximately two years. It is recommended to replace the regulator within two years from the date of manufacture.
• Gas cylinders must not be stored in enclosed spaces.
• The hose length must not exceed 1.5 m.
• The hose must not be twisted or tangled.
• Use the designated points for leading the hose line, if available (see assembly instructions).
• Grill and gas bottle must be placed so the hose doesn’t get tangled.
• Do not place the gas bottle inside or underneath the grill, unless it is explicitly authorised.
• Do not store gas cylinders near the grill, which are not required for operation.
• Make sure that any existing vents are always open and free.
• Should the flame go out during cooking, turn off all gas valves, open the lid and wait five minutes before igniting the grill again.
• Make sure that no ignition sources are close to the grill while connecting or changing the gas bottle.
• Do not use the grill to heat substances and materials other than food.
• Do not use the grill as a heater.
• Do not use the grill in closed rooms, garages, tents or other closed places. The resulting heat and sparks is a potential fire hazard.
• Do not use the grill under flammable roofs, shelters and similar places.
• Keep the grill at least two metres from flammable materials to avoid fire hazards.
• Never leave the hot grill unattended.
• Attention: Ensure the grill is off and completely cooled before cooling.
• Always wear oven mitts when touching the grill.
• This grill is only intended for private use!
• Clean the grill regularly – do not use flammable or hash cleaning products.
• Wait for the grill to cool down before cleaning.
• Never alter or modify this appliance – any modifications will void your warrenty.
• Remains of grilled food (fats, proteins and salts) contain corrosion-accelerating substances that attack your grill. The same applies to ash in combination with moisture (rain or condensed water). Please clean your grill carefully after each use.

SAFETY INFORMATIONS

Danger! – If you smell gas

1. Immediately close the gas valve.
2. Immediately extinguish all open flames.
3. Open the lid.
4. Do not operate any electrical devices.
5. If the smell of gas persists, keep a safe distance from the product and inform your gas supplier or fire department.

Leaking gas is an explosion and fire hazard that can cause serious injury or death. In confined spaces, asphyxiation could occur.

Leak testing
All gas connections on the grill are tested for leaks before delivery. However it is necessary to perform a complete leak test before first use. Run the test on the entire system at regular intervals and before every use. Do the test immediately if you smell gas.

1. Ensure that all controls are off.
2. Ensure the pressure reducer is connected to the gas bottle.
3. Open the gas valve completely by turning it anticlockwise. If you hear a whistling sound, turn the gas valve immediately – there is a leak at the connection.
4. Check each connection of the cylinder to the gas manifold by brushing or spraying the soap solution on the connections.
5. If bubbles form somewhere, there is a leak. Turn off the gas bottle valve and tighten the connections. Open the valve and check again.

Be aware!

• Make sure that all packaging materials including the fastening straps of the burner are safely removed.
• Do not smoke while doing the leak test.
• Never perform a leak test with an open flame.
• Prepare some soap solution (mix water with soap)
• The leak test should only be performed outdoors and away from ignition sources such as gas , electric devices and combustible materials.
• Keep the grill away from open flames or sparks during the leak test.

Maintenance
Keep the barbecue area clean and free of combustible materials. Keep the burner holes clean, to obtain a sufficient ventilation of the device. Visual inspection of the burner flames are as follows: When working, the burner flames are mostly blue in colour with a slight yellow tip. If faulty, the burner flames are mostly yellow and have an uneven shape with a strong flickering. There may be an excessive noise as well. In this case the burner and the gas valve must be cleaned immediatly.

CLEANING INFORMATIONS

General cleaning information
Clean the grill regularly. Do not use flammable or harsh cleaners. Do not use metal brushes or tough sponges to clean the surface.
Wait for the grill to cool down before cleaning.
To get the best out of this grill, it is recommended to clean the device after every use.

Burner cleaning

1. Close the gas line.
2. Remove the gas distributor.
3. Check the inside of every burner using a flashlight.
4. Clean the burner insides using a wire.
5. Check and clean the openings at the burner ends.
6. Check and clean the valve nozzles.
7. Clean the outsides of the burner using a wire brush. This keeps internal passageways free of debris.

Cleaning the grease tray
The grease tray should be emptied and wiped regularly. Only use mild cleaners and warm water for cleaning.
A small amount of sand can be placed inside the tray to absorb the grease.
Spiders and insects
This grill can be a target for spiders and insects like all outdoor products – they like to nest in areas around the burner tube. This can lead to blocking the gas flow and result in a flowback through the air openings.
This can cause a fire around the combustion air openings under the panel, causing damage to your grill. It is recommended to check the burners at least once a year.

Check and clean the burners if the following symptoms occur:

1. Smell of gas with a yellow and weak flame.
2. The grill does not reach an appropriate temperature.
3. The grill heats irregularly.
4. The burner does not ignite.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>