BALiLA CM-100 Wireless Conference Microphone User Manual

June 9, 2024
BALiLA

BALiLA CM-100 Wireless Conference Microphone User Manual
BALiLA CM-100 Wireless Conference Microphone

Product Preview

Product Preview

Fig 1 Speaker

  1. USB-C Charging Port
  2. Mute/ Unmute (The blue indicator lights up for recording status)
  3. Volume-
  4. volume+
  5. 3.5mm Socket

Fig ii Transmitter

  1. Omnidirectional Microphone (360° pick-up)
  2. Power Button
  3. Lapel Clip
  4. Power Indicator
  5. USB-C Charging Port

Receiver
Fig ⅲ Receiver

  1. 3.5mmPlug
  2. Power Button
  3. Power Indicator
  4. USB-C Charging Port

How to use

  1. Connect the Speaker to the computer with a USB-c cable and a USB adaptor;
    How To Use

  2. Plug the receivers into the Speaker;
    How To Use

  3. Power on the transmitters and receivers, the green indicator of the transmitters and receivers are both on, and then you can start using them.
    How To Use

Indicator Light Instructions

Speaker Unmute Blue light on
Muted Blue light off

Transmitter&
Receiver| connected| Steady green
Low battery state| Slow flashing red
While charging| Steady red
finished charging| Red light off

Product Parameters

  • Charge input: 5V 2A
  • Charging time: 1h
  • Talk time: 10h
  • Frequency Range: 120Hz- 20KHz
  • Working Frequency: 2402-2480MHz
  • Working Range: 20m
  • Application System: Windows XP/7/8/10 and mobile phone
    systems, plug and use, no need to install drivers

Speaker

  • Driver size: 1*2 inches (internal magnetic horn)
  • Frequency Response: 100Hz-16KHz
  • Rated output power: 5W RMS
  • Audio Input Interface: 3.5mm jack (5 ports in total)
  • Function: Volume+, Volume-, mute/ unmute
  • Output Interface: USB-C jack

Transmitter (Microphone)

  • Pickup Mode: Omnidirectional(360° pick-up)
  • Power Supply: Built-in 110maH lithium battery
  • Charging Port: 5V 500MA (USB-C input)

Receiver

  • Power Supply: Built-in 110maH lithium battery
  • Charging Port: 5V 500MA (USB-C input)
  • Audio output interface: 3.5mm plug

Packing List

Speaker X1, Transmitter X5, Receiver X5, USB-C cable X1, 1-in-10 charging cable X1

udaoRF exposure statement

This equipment complies with the FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

FCC Warning

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Customer Service

References

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals