TUSK 2073560001 Windshield Washer Kit Instruction Manual
- June 10, 2024
- TUSK
Table of Contents
TUSK 2073560001 Windshield Washer Kit
INSTALLATION INSTRUCTIONS
BEFORE YOU BEGIN
Read these instructions and check to be sure all parts and tools are accounted for. Please retain these installation instructions for future reference and parts ordering information
PARTS INCLUDED
- 2 – M6x5 Bolts
- Washer Reservoir
- 1 – 6’ Wire Harness
- 2 – M6 Nuts
- 2 – Sprayer Nozzles
- 1 – 10’ Wire Harness
- 2 – M6 Washers
- Momentary Rocker Switch
- 15’ 4mm Clear Hose
- T Connector
- Straight Connector
Instructions
Note: This is a universal kit, some things may be different from machine
to machine.
Step 1. Start by locating a place to mount the washer reservoir. Once you
have located a place mark and drill 2 holes for the reservoir mounting
bracket. Once the holes are drilled you will use the 2 M6x5 bolts, Nuts, and
washers to secure the reservoir mount.
Step 2. Run the 10’ Wire harness from the plug up to the rocker switch.
Connect the ground on this harness to #8, and the positive to #3 on the back
of the Rocker Switch. From there you will run the 6’ Wire harness from the
Rocker switch to a key on power source. When you connect the 6’ harness to the
rocker switch you will connect the ground wire to #8 on the rocker switch and
the positive to #2.
Step 3. Next you will find a good place for the sprayer nozzles on the
front end of your machine.
Once you know where you would like to mount them, drill a hole, and mount the
sprayer
nozzles. From here you will need to run the clear hose from the reservoir to
each sprayer. Once this is done fill the reservoir with windshield washer
fluid and spray the windshield. Some adjustment may be needed on the sprayer
nozzles. You can adjust these with a small needle. Once it is adjusted where
it needs to be the installation process is complete.
Wiring Diagram
Mounting Example
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>