Super Fast WCHAR000X Wireless Charger User Manual
- June 5, 2024
- Super Fast
Table of Contents
Wireless charger
Charger sans fil
WIRELESS CHARGER
TECHNICAL SPECIFICATIONS
- COMPATIBLE WITH SMARTPHONES WITH Qi TECHNOLOGY
- CHARGES THROUGH MOST CASES: WORKS WITH NON-METALLIC CASES, WITHOUT MAGNETIC PARTS, AND WITH A MAXIMUM THICKNESS OF 3 mm.
- PROTECTS AGAINST OVERLOAD, SHORT CIRCUIT, AND OVERHEATING.
- FOR PROTECTION: IF THERE ARE METAL OBJECTS PLACED ON THE WIRELESS CHARGER, OR BETWEEN THE CHARGER AND THE SMARTPHONE (EG. CREDIT CARDS, KEYS, COINS, BATTERIES, OR JEWELLERY), CHARGING WILL NOT START BECAUSE THEY MAY OVERHEAT OR INTERFERE WITH THE PROCESS.
- LED CHARGING LIGHT: INDICATES IF THE SMARTPHONE IS POSITIONED CORRECTLY AND IS CHARGING
- POWER: MAX. 10 W
IF YOUR SMARTPHONE DOES NOT SUPPORT FAST WIRELESS CHARGING, IT WILL BE CHARGED AT THE STANDARD 5 W SPEED - INPUT: 9 V 1.67 A, 5 V 2 A
- OUTPUT: 9 V 1 A, 5 V 2 A
- INPUT FREQUENCY: 50 Hz
- OUTPUT FREQUENCY: 110-205 kHz
- CHARGING EFFICIENCY: ABOUT 70%
- USB/USB-C CABLE INCLUDED (LENGTH: 1 m/39″)
INSTRUCTIONS FOR USE
- INSERT THE USB-C END INTO THE WIRELESS CHARGER AND THE USB END INTO A USB POWER SOCKET; THE LED LIGHT WILL TURN BLUE. AFTER A FEW SECONDS THE LED LIGHT WILL TURN OFF, AND THE WIRELESS CHARGER IS READY.
- PLACE THE WIRELESS CHARGER ON A FLAT SOLID SURFACE, SUCH AS A DESK.
- PLACE YOUR SMARTPHONE DIRECTLY ON THE WIRELESS CHARGER WITH THE SCREEN FACING UPWARDS.
- THE SMARTPHONE WILL START CHARGING AUTOMATICALLY AFTER A FEW SECONDS. DURING CHARGING, THE LED IS BLUE. IF THIS IS NOT THE CASE, MAKE SURE THAT YOUR SMARTPHONE IS POSITIONED CORRECTLY ON THE WIRELESS CHARGER AND THAT THERE ARE NO FOREIGN OBJECTS ON THE CHARGER OR BETWEEN THE CHARGER AND YOUR SMARTPHONE.
- THE CHARGING TIME DEPENDS ON THE TYPE OF SMARTPHONE. YOUR SMARTPHONE WILL INDICATE THE PROGRESS OF THE CHARGING. YOU CAN REMOVE YOUR SMARTPHONE FROM THE WIRELESS CHARGER AT ANY TIME DURING CHARGING.
- WHEN YOUR SMARTPHONE IS REMOVED FROM THE WIRELESS CHARGER, THE BLUE LED WILL TURN OFF AUTOMATICALLY. WHEN CHARGING IS COMPLETE, THE GREEN LED WILL LIGHT UP. REMOVE YOUR SMARTPHONE FROM THE WIRELESS CHARGER.
KEEP THE WIRELESS CHARGER IN A WELL-VENTILATED AREA WHEN IN USE.
SAFETY INSTRUCTIONS
- THIS DEVICE IS INTENDED FOR INDOOR USE ONLY. DO NOT USE OUTDOORS WITH EXPOSURE TO THE ELEMENTS.
- DO NOT IMMERSE THE CABLE, PLUG, OR BASE IN WATER OR OTHER LIQUIDS.
- ALWAYS DISCONNECT THE DEVICE WHEN NOT IN USE OR BEFORE CLEANING It
- TO PREVENT FIRES OR ELECTRIC SHOCKS, DO NOT EXPOSE THE APPARATUS TO RAIN OR MOISTURE.
- DO NOT EXPOSE THE APPARATUS TO DRIPPING OR SPLASHING AND DO NOT PLACE IT IN HUMID AREAS SUCH AS A BATHROOM.
- DO NOT EXPOSE THE APPARATUS TO DIRECT SUNLIGHT OR HEAT SOURCES (SUCH AS HEATING, HOBS, OVENS … ETC.).
- DO NOT EXPOSE TO EXTREME TEMPERATURES IN HOT OR COLD ENVIRONMENTS OR TO EXTREMELY LOW AIR PRESSURE WHICH CAN CAUSE IT TO EXPLODE OR FLAMMABLE LIQUIDS OR GASES TO ESCAPE.
- DO NOT SUBJECT THE APPARATUS TO STRONG IMPACTS AND DO NOT LET IT FALL.
- ALLOW THE DEVICE TO COOL BEFORE CLEANING IT.
- TO CLEAN THE DEVICE EXTERNALLY, USE A DRY, SOFT, AND CLEAN CLOTH ONLY.
- DO NOT USE DETERGENTS CONTAINING ALCOHOL AMMONIA, BENZENE, OR ABRASIVES AS THEY COULD DAMAGE THE APPARATUS.
- SUPERVISION OF AN ADULT IS REQUIRED WHEN THE DEVICE IS USED NEAR A CHILD.
- MAKE SURE THAT THE POWER OF THE DEVICE CORRESPONDS TO THAT OF THE PRODUCT
- DO NOT COVER IT WHEN CHARGING.
- DO NOT ATTEMPT TO REMOVE THE BUILT-IN BATTERY BY YOURSELF AS IT MAY OVERHEAT, CATCH FIRE OR CAUSE INJURY.
- THE SAFE USE OF THE PRODUCT IS NO LONGER GUARANTEED IF: IT HAS VISIBLE DAMAGE, IS NOT WORKING PROPERLY, HAS BEEN STORED FOR PROLONGED PERIODS IN ADVERSE ENVIRONMENTAL CONDITIONS, OR HAS BEEN EXPOSED TO CONSIDERABLE STRESS WHILE BEING TRANSPORTED. IF ONE OF THE SITUATIONS DESCRIBED ABOVE OCCURS, STOP USING IT.
- THIS PRODUCT IS NOT A TOY. KEEP IT OUT OF THE REACH OF CHILDREN.
- DO NOT USE THIS PRODUCT FOR ANYTHING OTHER THAN ITS INTENDED PURPOSES.
- DO NOT USE THE DEVICE IF THE CORD IS DAMAGED OR NOT WORKING PROPERLY.
IMPORTANT WARNING FOR THE PROPER DISPOSAL OF THE PRODUCT
THE EUROPEAN DIRECTIVE 2012/19/EU ON WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT
(WEEE) STATES THAT THESE DEVICES MUST NOT BE DISPOSED OF IN THE NORMAL
UNSORTED URBAN WASTE STREAM, BUT COLLECTED SEPARATELY TO OPTIMIZE THE RECOVERY
AND RECYCLING FLOW OF THE MATERIALS THEY ARE MADE OF AND TO PREVENT POTENTIAL
HARM TO HEALTH AND THE ENVIRONMENT DUE TO THE PRESENCE OF POTENTIALLY
HAZARDOUS SUBSTANCES.
THE CROSSED-OUT WASTE CONTAINER SYMBOL IS SHOWN ON ALL DEVICES TO REMIND YOU
OF THIS.
THE WASTE CAN BE DELIVERED TO SPECIAL RECYCLING CENTRES, OR CAN BE HANDED OVER
FREE OF CHARGE TO THE DEALER WHERE YOU PURCHASED THE EQUIPMENT UPON PURCHASING
A NEW EQUIVALENT ONE, OR WITH NO OBLIGATION TO PURCHASE A NEW ONE IF THE
DEVICE IS SMALLER THAN 25 cm/9.75″.
FOR FURTHER INFORMATION ON THE CORRECT DISPOSAL OF THESE DEVICES, YOU CAN
CONTACT THE RELEVANT PUBLIC AUTHORITY.
NOTE: THIS EQUIPMENT HAS BEEN TESTED AND FOUND TO COMPLY WITH THE LIMITS
FOR A CLASS B DIGITAL DEVICE, PURSUANT TO PART 15 OF THE FCC RULES. THESE
LIMITS HAVE BEEN DESIGNED TO PROVIDE REASONABLE PROTECTION AGAINST HARMFUL
INTERFERENCE IN A RESIDENTIAL INSTALLATION.
THIS EQUIPMENT GENERATES, USES, AND CAN RADIATE RADIO FREQUENCY ENERGY AND, IF
NOT INSTALLED AND USED IN ACCORDANCE WITH THE INSTRUCTION MANUAL, MAY CAUSE
HARMFUL INTERFERENCE TO RADIO COMMUNICATIONS.
HOWEVER, THERE IS NO GUARANTEE THAT INTERFERENCE WILL NOT OCCUR IN SOME
PARTICULAR INSTALLATION.
IF THIS EQUIPMENT DOES CAUSE HARMFUL INTERFERENCE TO RADIO OR TELEVISION
RECEPTION, WHICH CAN BE DETERMINED BY TURNING THE EQUIPMENT ON AND OFF, THE
USER IS ENCOURAGED TO TRY TO CORRECT THE INTERFERENCE BY ONE OR MORE OF THE
FOLLOWING MEASURES:
- REORIENT OR RELOCATE THE RECEIVING ANTENNA.
- INCREASE THE DISTANCE BETWEEN THE EQUIPMENT AND RECEIVER.
- CONNECT THE EQUIPMENT INTO AN OUTLET ON A CIRCUIT DIFFERENT FROM THE ONE TO WHICH THE RECEIVER IS CONNECTED.
- CONSULT THE DEALER OR AN EXPERIENCED RADIO/TV TECHNICIAN FOR HELP
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
CAUTION: CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY LEGAMI COULD
VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
READ CAREFULLY AND KEEP IT FOR FUTURE REFERENCE.
FCC Instructions:
This product has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This product generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If the product does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the product and receiver.
– Connect the product into an outlet on a circuit different from that to which
the receiver is connected.
– Consult the dealer or an experienced radio/tv technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could avoid the user’s authority to operate the
product.
FCC Radiation Exposure Statement:
The equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.