Agri-ID Goat EID Leg Band Instruction Manual
- June 10, 2024
- Agri-ID
Table of Contents
LB01F LEG BAND FOR GOATS
Application Instructions
1. Separate the locking pin from the leg band
2. Wrap the band around the leg to determine the right size
3. The leg band can be widened for a better fit by removing one or more of the three steps with a plier
4. When wrapping the band around the leg, be sure to fit it in place
using the `nose’ located on the center cavity (see illustration). Insert the
locking pin through the three cavities, starting with the widest. Push the
part remaining at the end of the band into the interior of the band, so that
it does not stick out
5. Pull the locking pin all the way over using a plier – at the end you should feel a click. The click is important as it confirms that the band was correctly applied
6. Once the leg bad has been correctly applied, the end part of the locking pin can be cut off
As the animal grows, the leg band can be widened by using pliers to remove one of the three steps.
Note:
No information is available regarding the suitability of this device for use
on kids and small goat breeds, so user discretion is advised.
Although the information presented in this Product Information Sheet is
believed to be accurate and reliable, no responsibility for inaccuracies can
be assumed by Datamars.
Performance data is typical only and variations due to component manufacturing
tolerances are normal. Datamars reserves the right at any time to change
performance characteristics or specifications without prior notice.
© Datamars 2023 All rights reserved.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>