Lakukom LA594A Bluetooth Headphones User Manual
- June 9, 2024
- Lakukom
Table of Contents
Lakukom LA594A Bluetooth Headphones
PACKAGE LIST
DIAGRAM
POWER ON/OFF
HOW TO PAIR
First use
- Turn on the Bluetooth function on your phone.
- Power it on, then it will enter the pairing mode automatically. Red and blue lights will start flashing alternately with the voice “Pairing”
- Search for the Bluetooth devices and select “Speed FLT”Enter the code “O000” if needed)
- When pairing is successful, the blue light will start flashing slowly. You will also hear the voice “Connected”
Pairto another device
- In the state of shut-down, hold on the MFB for 5-6 seconds or so. Don not release it until the red and blue lights start flashing alternately with the voice Pairing
- The rest goes the same as above.
MULTIFUNCTION BUTTONS
Play/Pause/Answer/ Hang Up / Reject/ Siri/ Mute/Redial
VOLUME CONTROL/MUSIC CONTROL
CHARGE BATTERY
NOTIFICATION
- Please fully charge it if it was going to lay idle for a long time and place it in a cool and dry place. Please recharge it each 2 months for storage
- Please fully charge it for the first use.
CORRECT DISPOSAL OF THIS PRODUCT
(Waste Electrical& Electronic Equipment)
This Marking shown on the product or its literature, indicate that it should
not be disposed with other household wastes at the end of its working life. To
prevent possible harm to the environment or human health from uncontrolled
waste disposal, please separate this from other types of wastes and recycle it
responsibly to promote the sustainable reuse of material resources. Household
user should contact either the retailer where they purchased this product, or
their local government office, for details of where and how they can take this
item for environmentally safe recycling. Business users should contact their
supplier and check the terms and conditions of the purchase contact. This
product should not be mixed with other commercial wastes for disposal.
FCC STATEMENT
Any Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment
NOTE: This equipment has been tested and found to comply with the limits for a Class digital device, pursuant to Part 15 of the FOC Rules. These limits are designed provide reasonable protection against hamful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and. if not installed and used in accordance with the instructions. may cause harmful interference to radio communications However, there is no guarantee that interference will not occur in a particular installation If this equipment does cause hamful interference to radio or television reception which can be detemined by turning the equipnment off and on, the user is encouraged to try to correct the interference by one or more of the following measures.
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC Rules Operation is subject to the following two conditions:
- This device may not cause harmful interference,
- This device must accept any interference received. including interference that may cause undesired operation. FCC Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>