TRIO 620010442 IRVINE LED Ceiling Light Instructions
- June 9, 2024
- Trio
Table of Contents
TRIO 620010442 IRVINE LED Ceiling Light
WARNING!
Before assembling, please read carefully the safety instructions!
TRIO Leuchten GmbH
TRIO International GmbH
Gut Nierhof 17
D-59757 Arnsberg
www.trio-lighting.com
WEEE-Reg. Nr.: DE78273666
TRIO Lighting Ibérica s.l.: RAEE 4544
TRIO Lighting Italia s.r.l.: RAEE IT13020000007829
TRIO Lighting Scandinavia Oy: WEEE PIR2005Y354114/2114
This product contains light source(s) of energy efficiency class(es)
Instruction
Description of how the light works without the remote control unit By the wall switch you can choice the following ligh modes
- 100 % cold white illumination at 6500K
- 100 % warm white illumination at 3000K
- Brightness 100% 4000K
- Night light
You can select it, with short turn on and turn off of the lamp.
The most recently configured light settings is always displayed (memory
effect)
The status of the light scenario is saved after 15 seconds. In order not to
change the saved status of the luminaire, the interval between restart
processes must not be shorter than 5 seconds.
Description of how the light works with the remote control unit
The most recently configured light settings is always displayed (memory
effect)
The synchronous control of several lights is not foreseen.
Operation of the remote control
-
On
-
Off
-
3 & 4. Brightness regulator: The adjustment takes place in stages. By pressing for a short period, it is possible to control the individual stages. Pressing the button permanently results in the maximum or minimum brightness being reached.
-
5 & 6. The adjustment takes place in stages. By pressing for a short period, it is possible to control the individual stages. Pressing the button permanently results in the wärmest or coldest colour setting being reached.
-
Mode: Cyclical modes switch
100 % cold white illumination at 6500K 100 % warm white illumination at 3000K Brightness 100% 4000K
Night light -
Night light
Set up remote control
Please disconnect the light from the mains for 10 seconds. Then switch the light on using the wall switch and at the same time press the “ON” button on the remote control. After about four seconds, the light confirms the successful programming by flashing several times. Now the light can be controlled with the remote control. The disengaging of the remote control works in the same way, except that the “OFF” button must be pressed instead of the “ON” button.
Declaration of Conformity
Hereby, Trio Leuchten GmbH. Gut Nierhof 17, D-59757 Arnsberg, declares that
this product is in compliance with Directive 2014/53/EU. The full text of the
EU declaration of conformity is available at the following internet address:
www.trio-leuchten.de
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>