gogonova GL3400150 LED Rechargeable Stand Work Light User Manual

gogonova GL3400150 LED Rechargeable Stand Work Light

WARNING! RISK OF SHOCK. House electric current can cause painful shock or serious injury unless handled

WARNING! Changes or modifications to this,unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment

• All Safety and Operating instructions in this manual must be followed before using this product.
• Follow all safeguards stated in the manual, in addition to normal safety precautions in working with electrical devices. Always follow basic safety precautions to reduce the risk of fire, electric shock and personal injury.
• Do not place near any heat source.
• To reduce the risk of electrical shock, do not put in water or other liquid. Do not place or store product where it can fall or be pulled into a tub or sink.
• Do not crush or incinerate.
• Do not insert foreign objects into this product.
• To reduce the risk of fire, keep away from combustible materials while in operation.
• To reduce the risk of injury, close supervision is necessary when this product is used near children.
• Do not attempt to repair, disassemble or modify under any circumstances.
• Do not smother lamp or place it near anything flammable.
• When folding the light blades to shut the unit, make sure lights are OFF. Do not turn lights ON while blades are collapsed and facing inward.

Maintenance and Care

Maintenance of this Work Light is minimal. Regularly clean the lens with a non-abrasive cleaning cloth. The same care should be provided for the stand.

Limited Warranty

This product is warrantied to be free from defects in workmanship and materials for up to 1 year from date of purchase. If the product fails within the warranty period, please contact Feit Electric at service@igogonova.com, or call 0086-18924668885 for instructions on replacement or refund. REPLACEMENT OR REFUND IS YOUR SOLE REMEDY. EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ANY IMPLI WARRANTIES ARE LIMITED IN DURATION TO THE DURATION OF THIS WARRANTY. LIABILITY FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES IS HEREBY EXPRESSLY EXCLUDED. Some states and provinces do not allow the exclusion of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state or province to province.

SPECIFICATIONS

NOTE : Battery indicators located in front of the work light must be fully lit to indicate full charge.

PARTS INCLUDED

NOTE : Parts not shown to actual size.

Assembly

1. Setting up the Tripod
   Push the bottom button to extend the tripod (Fig. 1) and open legs (Fig. 2).

2. Attaching the Lamp Head to the Tripod
   Screw in work light clockwise to set into place (Fig. 3).

3. Adjusting the Work Light Blades
   Gently rotate the Work Light Blades to the desired angle

4. Using the Built-in Hook, Magnets and standard Tripod Mount
   Mounting options are located at the bottom of the Work Light. Extend out the hook and hang on a secure location (Fig. 5). Use integrated magnets to mount on metal surface (Fig. 6). Screw onto included tripod or a standard 1/4-inch mount (Fig. 7).

Operating Instructions

Change Light Settings
Brightness settings Touch the button to turn on and cycle through the brightness settings

• Press power button once for LOW
• Press again for MEDIUM
• Press again for HIGH
• Press again for OFF When not using, make sure light is OFF.

Color Temperature Settings
Touch the button to switch between Cool White (4000K) and Daylight (65001) (Fig. 9).

Charging the Work Light
To fully charge the light, plug included USB-C cable and power supply into charging port (Fig.10). Charge time is approximately 3 hours 30 minutes or until all four charging indicators are lit. Charge time may vary.

NOTE : Make sure charging port protector is securely closed when not charging to minimize debris and moisture.

Battery Indicator Lights
Battery indicator lights will blink while charging. All lights will be lit when plugged in and fully charged

Environmental Protection
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice

Linkzone Technology Co., Limited Room 510, 5/F, Wayson Commercial Building, 28 Connaught Road West, Sheung Wan, Hong Kong

• 0086-189 2466 8885
• service@igogonova.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>