SPORTSOUL IS200 Trampoline Somatosensory Game User Guide
- June 9, 2024
- SPORTSOUL
Table of Contents
SPORTSOUL IS200 Trampoline Somatosensory Game User Guide
BATTERY INSTALLATION
Please put the device back up, open the its back cover using a screwdriver,
put the button cell into the slot with ‘+’ facing outward, and then close the
back cover.
INSTALLATION METHOD
Fasten the device belt around the waist of the user
ON/OFF
Make sure the button cell is installed correctly with normal power level.
ON: the device will be turned on after shaking 3 times.
OFF: the device will get into standby mode if it’s kept in still status
for more than 3 minutes
CONNECTION
Make sure the Bluetooth and geo-location of the phone or iPad are turned on
properly. Put the device close to your phone or iPad,log in the APP, select
“Start ” on the “Sports” page, search for the device and connect according to
the prompts
WARRANTY CARD
Customer Information
FIRMWARE UPGRADES
In order to continuously improve the user experience, we will continuously
release new device firmware for you to upgrade, please keep phone or iPad
connected to the device normally, and ensure that the battery level is not
less than 50%. Select “My Device” in the “My” page of the APP, then click
“Firmware Version”. Follow the prompts to finish the upgrade..
STATUS INDICATION
The sensor has an indicator light, it is used to indicate different states.
STATES | COMMENT |
---|---|
Continuous flashing 3 times | Active State (not connected) |
Flashing every 15 seconds | Waiting for the pairing |
Flashing every 5 seconds | Under normal connection |
Always on | Firmware being upgraded |
Light fading out | Going into standby status |
Quick flashing | Malfunction |
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
FCC WARNING
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
MODIFICATION: Any changes or modifications not expressly approved by the grantee of this device could void the user’s authority to operate the device.
STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.