AMERICAN TENT 20×20 Party Pole Tent Canopy Installation Guide
- June 9, 2024
- AMERICAN TENT
Table of Contents
20×20 Party Pole Tent Canopy
Installation Guide
20×20 Party Pole Tent Canopy
ALL-PURPOSE CANOPY PARTS LIST. 
| PARTS | CANOPY SIZE |
|---|---|
| 10 x 10 |
12 x 12
THROUGH
20 x 20
| 20 x 30| 20 x 40
SIDE POLE| 4| 8| 10| 12
CENTER POLE| 1.| 1| 2| 3
STAKES| 8| 12| 14| 16
BAG WITH TOP| 1| 1| 1| 1
BAG FOR POLES| 1| 1| 1| 1
BAG FOR STAKES| 1| 1| 1| 1
MANPOWER REQUIRED
Two installers should be able to assemble an All-Purpose Canopy in
approximately thirty minutes.
TOOLS REQUIRED Sledge Hammer
INSPECT SITE CAUTION : Consult local utility company prior to
installation.
Prior to assembly be sure to look around area for obstacles, pipes, wires,
etc.
LAYOUT & CHECK Use parts list for a quick identification and check list
for proper quantities.
LAYOUT AT SITE
20′ X 20′ canopy used as example. Spread drop cloths and unroll canopy at
exact position of desired finished assembly. Any sharp objects which must
remain on site under the canopy should be padded and taped. Assemble side
poles and lay straight out form each pole hole in canopy. Qrive a stake 11-0″
from the end of each pole. The stake must be driven through the ring attached
to each guy rope as shown. 
RAISE SIDE POLES
Start at opposite corners. Insert side-poles into pole notes and.raise so that
bottom of poles slant toward center of canopy.
Adjust guy rope. Continue with other two corners and then sides.
RAISE CENTER POLE
Assemble three piece center pole and Insert into center pole hole. Raise to
upright position and tie off jump rope to pole.
SIDE POLE ADJUSTMENT
Tighten guy ropes and then set side poles to upright position. Adjust pole
positions and guy rope tension to properly pull out canopy. Protective covers
are recommended for all stakes.
TAKE DOWN
Loosen all guy ropes. Spread drop cloths. Reverse steps 1 through 4 for
disassembly.
IMPORTANT:
Check Guys Ropes periodically for tightness and maintaining of good condition.
Stakes provided are for average soil conditions. Sandy soil or asphalt may
require additional staking. Proper installation suitable to site conditions is
the responsibility of the installer. Store canopy in a cool. dry area. Never
store while wet or damp.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>