WOFI 7722.03.64.0006 SAVANNAH Pendant Lamp Instruction Manual

: June 4, 2024
: WOfi

Table of Contents

Introduction
Electrical danger
Approved use
Safety notices
Items supplied
Set-up
Functioning
Technical Data
Guarantee
Disposal
Manufacturer’s address
Read User Manual Online (PDF format)
Download This Manual (PDF format)

SAVANNAH
Operation instructions

These operating instructions belong exclusively to the SAVANNAH lamp. They contain important information on putting into operation and handling. Keep the instructions in a safe place in order to be able to refer to them at any time. In the event of passing on the light fitting to a third party these operating instructions should also be passed on.

Introduction

Dear customer,
Thank you for purchasing this light. With this light, you have acquired a product that has been manufactured using the very latest technology. This product complies with applicable European and national standards. In order to keep it in this condition and to ensure safe operation, you, as user, must follow these operating instructions.

Electrical danger

Connect the light only to a legally installed electrical power supply, whose voltage matches the light’s technical data (also see type indicator for details).
When servicing the light, for example when cleaning it or replacing the light bulb, the light must be switched off. To do this press the appropriate switch.
If the lamp is damaged, then you must disconnect it from the power supply. The light can only be reconnected and used again once it has been repaired by an authorized person.
Keep children away from this electrical appliance.

Approved use

The light is intended only to be used indoors in dry environments.
Avoid children operating the light.
The light must not be used in spaces where there is a risk of explosion.
The light is not suitable for use in commercial situations.

Safety notices

The power supply must be disconnected before assembling or servicing the light.
Electrical power supply must be installed by a qualified electrician.
Unauthorized changes or alterations to the light are not permitted for safety reasons.
Ensure that you use the light correctly. To ensure correct use, read these operating instructions.
Never hang any object on or above the light. There is a risk of short-circuiting and fire.
Do not use the light near liquids and avoid contact with water.
Keep packaging material and plastic bags out of the reach of children as there is a risk of suffocation.
Keep children away from the light.
The light is only designed to be used in domestic living spaces. It is not suitable for use in commercial situations.
If the light or its cable shows signs of damage, then it must not be operated. In such cases immediately disconnect the light from the power supply.
Before operating the light, make sure the bulb is properly fitted in its holder.
Around the light bulb, the light gets hot. For this reason, make sure that flammable objects are kept at a distance of at least 0.3 meters.
Light bulbs must only be replaced with bulbs of the same type and power. When replacing light bulbs, do not hold them in your bare hands. If this happens, then the new bulb must be cleaned with a non-greasy cleaning product which leaves no residue.
Only handle the bulb after allowing it to cool down for a few minutes as there is a risk of burning.
No responsibility will be accepted for damage to persons or objects caused by incorrect operation or failing to comply with the safety notice. Guarantees are rendered invalid in such cases.

Items supplied

High voltage hanging light
Glass shades
Energy saving lamps
Operating instructions

Check that you have all these items and that they have not been damaged Light bulbs must only be replaced with bulbs of the same type and power. Damage caused by failing to comply with these operating instructions or as a result of modifications made will invalidate the guarantee. No consequential liability will be accepted.

Set-up

Before setting the light up, please note the following:

before using the light, please ensure that all screw connections are tightly done up
Making fine adjustment to the wires if, after installing the light in your ceiling, the counterweights or the hanging lights are not hanging straight, then the wires will need to be adjusted. To do this, move the pushbutton (A) on the light`s connection unit to one side. Now the wires can be pulled out of the unit a little, or pushed into it, or even rotated a little. After releasing the push button, the wires will be fixed in their new positions.
The wires must not be pulled over sharp edges, tightly crimped, shortened, or lengthened.
No ornamental objects may be hung on the wires.
If the wires` insulations are damaged and the red interior insulation becomes visible, then the light must be switched off at once and dismantled by a qualified electrician.

Functioning

To adjust the height, only ever pull on the counterweight or on the wires (not on the glass shade or on the metal tube

CAUTION: VERY HOT !

Please do not use any jerky movements to adjust the wires..

Technical Data

Voltage: max. 230 V ~
Safety class: I
Type of protection: IP20
Added bulbs: Energy-saving lamps E14/5,5W
Note the lamps type indicator.

Symbols:

| Smallest distance to lighted areas or combustible materials (in meters)
---|---
| Light suitable for fitting to or using on normal inflammable surfaces (wooden ceilings, etc.)
| Always replace a cracked protective cover.

In order to improve our products, we reserve the right to make visual and technical changes. Light bulbs must only be replaced with bulbs of the same type and power.

Guarantee

Our lights are made from the finest materials and are manufactured using the latest technology. They undergo continuous quality control and process monitoring.
We are therefore able to provide our lights with a two-year warranty covering function, processing, and construction. The period of the guarantee begins from the date of purchase, as indicated on your till receipt.
If a problem still arises, please contact your supplier or our service department immediately. Problems and damage caused by normal wear and tear, incorrect assembly, improper use, or unauthorized modifications are excluded from this guarantee.

Disposal

Dispose of all packaging correctly.
If you wish to dispose of the article, do so in accordance with all currently applicable regulations.
Information is available from local authorities.