Trust AGC-200 Waterproof Socket Dimmer User Guide

: June 9, 2024
: Trust

Table of Contents

Trust AGC-200 Waterproof Socket Dimmer
INSTRUCTION
Set dimming range
Safety Instructions
TECHNICAL SPECIFICATIONS
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Trust AGC-200 Waterproof Socket Dimmer

INSTRUCTION

Place Dimmer

A Connect the lamp to the dimmer and place the dimmer in a socket outlet.
B The dimmer pairing mode will be activated. Pairing mode lasts for 6 seconds.

Trust-AGC-200-Waterproof-Socket-Dimmer-1

Pairing the dimmer with a transmitter
Send an ON signal within 6 seconds with a Trust Smart Home transmitter during pairing mode. The dimmer can store up to 32 different transmitters in its memory. The paired transmitters are kept if the dimmer is moved to another socket outlet.

Control the dimmer

A Press the ON button with the assigned channel on the paired transmitter to turn on the dimmer/lamp. Do not exceed the maximum load: 200W.
B Press the OFF button with the assigned channel on the paired transmitter to turn off the dimmer/lamp.

Should your lights vibrate check whether your lamp is dimmable or try another dimmable lamp.

Set dimming range

Each type of lamp (incandescent lamp, halogen or dimmable LED lamp) has a different dimming range. Therefore you can set a lowest dimming value for the type of lighting that is connected.

A Put the dimmer in pairing mode. (See chapter 1)
B During pairing mode, press and hold the ON button for 3 seconds. (for the ACCT-510 and ACST-9900 the ON-OFF button).
C The lamp will flash 2x to confirm that the dimming range can be set
D Give an ON signalwith the paired transmitter to increase the dim level 1 step. Give an OFF signal to decrease the dim level 1 step.
E When the desired dimming range has been selected, press and hold the ON button for 3 seconds. (for the ACCT-510 and ACST-9900 the ON-OFF button)
F The connected lighting will flash 2x and dim to the lowest dim level as confirmation that the dimming range has been saved

Trust-AGC-200-Waterproof-Socket-Dimmer-2

Activate dimming sequence

A Press the ON button of a paired transmitter to turn on the receiver.
B Press ON again to start the dimming sequence activate
C Press ON a third time to lock the desired dimming level.

The dimming sequence will stop and lock automatically at the highest or lowest point when no signal is given with a transmitter.

Optional: Remove transmitter from dimmer

A Remove the dimmer from the socket outlet. After 6 seconds, plug the dimmer back into the socket outlet.
B The pairing mode will be activated for 6 seconds. Send an OFF signal within 6 seconds with a paired channel of the Trust Smart Home transmitter to unpair it.
C The connected lamp will flash 2x to confirm unpairing.

Trust-AGC-200-Waterproof-Socket-Dimmer-3

Optional: Clear memory

A Remove the dimmer from the socket outlet. After 6 seconds, plug the dimmer back into the socket outlet.
B The pairing mode will be activated for 6 seconds. Send an GROUP OFF signal within 6 seconds with a paired channel of the Trust Smart Home transmitter to clear the memory.
C The connected lamp will flash 2x to confirm unpairing.

Safety Instructions

Product support: www.trust.com/71278. Warranty conditions: www.trust.com/warranty
To ensure safe handling of the device, follow the safety advice on: www.trust.com/safety
The Wireless range is strongly dependent on local conditions such as the presence of HR glass and reinforced concrete Never use Trust Smart Home products for life-support systems. This product is water-resistant. Do not attempt to repair this product. Wire colors may vary per country. Contact an electrician when in doubt about wiring. Never connect lights or equipment that exceed the maximum load of the receiver. Exercise caution when installing a receiver voltage may be present, even when a receiver is switched off. Radio transmission frequency range: 433,92 MHz Disposal of packaging materials – Dispose of packaging materials which are no longer needed in accordance with applicable local regulations.
Disposal of the device – The adjacent symbol of a crossed-out wheelie bin means that this device is subject to Directive 2012/19/EU.
Disposal of batteries – Used batteries may not be disposed of in household waste. Only dispose of batteries when they are fully discharged. Dispose of batteries according to local regulations.

Trust Electronics Ltd. declares that item number 71278/71278-02 is in compliance with Directive Electromagnetic Compatibility Regulations 2016, Radio Equipment Regulations 2017. The full text of the declaration of conformity is available at the following internet address: www.trust.com/compliance
Trust International B.V. declares that item number 71278/71278-02 is in compliance with Directive 2014/53/EU –2011/65/EU. The full text of the EU declaration of conformity is available at the following web address: www.trust.com/compliance

Declaration of Conformity
Trust International B.V. declares that this Trust Smart Home-product:
Model: AGC-200 WATERPROOF SOCKET DIMMER
Item number: 71278/71278-02
Intended use: Outdoor is in compliance with the essential requirements and other relevant provisions of the following directives:
ROHS 2 Directive (2011/65/EU)
RED Directive (2014/53/EU)
The full text of the EU declaration of conformity is available at the following web address: www.trust.com/compliance
TRUST SMART HOME
LAAN VAN BARCELONA 600
3317DD DORDRECHT
NEDERLAND
www.trust.com

Trust Electronics Ltd.,
Sopwith Dr, Weybridge, KT13 0NT, UK.
All brand names are registered trademarks of their respective owners.
Specifications are subject to change without prior notice. Made in China