Trust AGST-8802 Double Outdoor Wall Switch User Manual

: June 9, 2024
: Trust

Table of Contents

Trust AGST-8802 Double Outdoor Wall Switch
INSTALLATION
Safety Instructions
TECHNICAL SPECIFICATIONS
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Trust AGST-8802 Double Outdoor Wall Switch

Item 71152 Version 1.0
Always read the instructions before using this product

INSTALLATION

Trust-AGST-8802-Double-Outdoor-Wall Switch-1

Trust-AGST-8802-Double-Outdoor-Wall Switch-2

Open wall switch
At the bottom of the two push-buttons is an opening. Use a flat screwdriver to carefully remove the two push buttons. Remove the push buttons, the frame and the rubber plate of the wall switch.
Place battery
Insert the battery into the battery compartment. Note the + and – terminals of the battery with the + and – symbols in the battery compartment.
Pair the wall switch with a receiver
To operate a receiver first you must pair the wireless wall switch with the receiver. Put the receiver in learning mode (see the manual of the receiver to activate the learning mode).
Give an ON signal on the wall switch with the correct button when the learning mode of the receiver is active. The receiver will give a confirmation that the pairing of the wall switch has been successful.
Follow the steps above to connect the other button with a receiver.
Mount the wall switch
Place the backplate of the wall switch on a surface. Screw the backplate of the wall switch in place using the supplied screws.
Place the rubber plate, the frame and the push buttons back on the backplate. Press the push buttons firmly in the frame of the AGST-8802 until a click is heard.
Operating the wall switch
- Dimming
1. Press the ON button to turn on the receiver.
2. Press the ON button again to activate the dimmode. The light will slowly dim in a cycle.
3. Press for the third time the ON button to secure the desired dim level.
4. Press the OFF button to turn off the receiver.
- Switching On/Off
1. Press the ON button to turn on the receiver.
2. Press the OFF button to turn off the receiver
- Open/Stop/Close
1. Press the ON button to open the blinds. Press the ON button again to stop the blinds.
2. Press the OFF button to close the blinds. Press the OFF button again to stop the blinds.
  Read the manual of the receiver to reverse the direction of the blinds.
- Activating wireless doorbell
  Press the ON button to activate the melody of the wireless doorbell.
  For more information, see the manual of the receiver

Unpair wireless wall switch
To unpair the wall switch put the receiver into learning mode. When the receiver is in learning mode give an OFF signal with the wall switch. The receiver will give a confirmation that the wall switch is unpaired.

The receiver can no longer be operated with the wall switch.

Clear the memory of the receiver
Consult the manual of the receiver to erase its memory.

Safety Instructions

Product support: www.trust.com/71152. Warranty conditions: www.trust.com/warranty
To ensure safe handling of the device, follow the safety advice on: www.trust.com/safety

The Wireless range is strongly dependent on local conditions such as the presence of HR glass and reinforced concrete Never use Trust Smart Home products for life-support systems. This product is water-resistant. Do not attempt to repair this product. Wire colors may vary per country. Contact an electrician when in doubt about wiring. Never connect lights or equipment that exceed the maximum load of the receiver. Exercise caution when installing a receiver voltage may be present, even when a receiver is switched off. Maximum radio transmit power: -10.25 dBm. Radio transmission frequency range: 433,92 MHz

Disposal of packaging materials – Dispose of packaging materials which are no longer needed in accordance with applicable local regulations.
Disposal of the device – The adjacent symbol of a crossed-out wheelie bin means that this device is subject to
Directive 2012/19/EU.

Disposal of batteries – Used batteries may not be disposed of in household waste. Only dispose of batteries when they are fully discharged. Dispose of batteries according to local regulations.

Trust Electronics Ltd. declares that item number 71152/71152-02 is in compliance with Directive Electromagnetic Compatibility Regulations 2016, Radio Equipment Regulations 2017. The full text of the declaration of conformity is available at the following internet address: www.trust.com/compliance
Trust International B.V. declares that item number 71152/71152-02 is in compliance with Directive 2014/53/EU – 2011/65/EU. The full text of the EU declaration of conformity is available at the following web address: www.trust.com/compliance

Declaration of Conformity
Trust International B.V. declares that this Trust Smart Home-product:
Model: AGST-8802 Outdoor wireless double wall switch
Item number: 71152/71152-02
Intended use: Outdoor is in compliance with the essential requirements and other relevant provisions of the following directives:
ROHS 2 Directive (2011/65/EU)
RED Directive (2014/53/EU)
The full text of the EU declaration of conformity is available at the following web address: www.trust.com/compliance

TRUST SMART HOME
LAAN VAN BARCELONA 600 3317DD DORDRECHT NEDERLAND
www.trust.com
Trust Electronics Ltd.,
Sopwith Dr, Weybridge, KT13 0NT, UK.
All brand names are registered trademarks of their respective owners.
Specifications are subject to change without prior notice. Made in China.