ZNP V8 Wireless Headphones Instruction Manual
- June 9, 2024
- ZNP
Table of Contents
ZNP V8 Wireless Headphones
Package Contents
Before Use
-
Turn off the headset,use the charging cable to connect the charger/computer/charging bank/etc to charge.
Note: Before using the headset for the first time charge for at least 2 hours. -
The red LED will turn on to indicate that the unit is charging: Once fully charged, the red LED will turn off.
Tips: Do not turn on the headset when charging the headset, or else it will lower the quality and the life of the battery.
Contents
- Place headset within 10M from Bluetooth-enabled device.
- Long press 35, the headset will be turned on. You will hear a prompt
- After opening the phone Bluetooth, click the < V8 to pairing.
- The headset will automatically tum off after 5 minutes without pairing.
Note: If the white light flashes quickly, the Bluetooth is not connected. If the white indicator blinks slowly, Bluetooth is connected. If the red light is steady on the being charged.
AUDIO LINE
Operation
-
* Long press: the prev song- Press.once: Nolumet
-
- Long Press 3s: Power on/Of
- Press once: Play/pause/ call control/hang up
- Long press 2S: Rejecta call
- Double-click the function key to switch the bass/pop mode
- Three-click button: Call back
- Long Press 3s: Power on/Of
-
- Long press: the next song
- Press once: Nolume-
-
- Type-C Charging Port
-
- 3.5mm AUX port
-
- LED indicator
-
- MIC
Safety Information
- If no pairing connection after the headset enters the pairing mode, please tum off the headset to save power.
- Do not perform other operations while pairing the headset to prevent the program error.
- Please select a proper volume while using to prevent damage to your ears.
- Please note that a good environment for using the headset can avoid damage to the headset.
- Please charge the headset after a long time none-use.
- When it’s charging with a USB cable, please turn off the power in order to avoid noise.
Specifications
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interterence to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
E-mail: usstore_vip@l63.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>