Banfer 2744908 Super Uneven Bars Instruction Manual

Banfer 2744908 Super Uneven Bars

You need a ratchet with a 19 mm socket and a 19 mm wrench.
We recommend at least 3 people to set up

Description

The uneven bars “Super” consists of a sturdy steel construction and has an integrated ret-ractable driving device made of 4 double swivel castors. For a safe stand, the standing areas are equipped with non-staining rubber foot pads.

The bar pillar have a height adjustment of 2.0-2.6 m for the upper bar and 1.2-1.6 m for the lower bar. The width can be adjusted from 0.53-1.15 m with a user-friendly hole grid sys-tem using spacers with quick clamping. Particularly practical: the U-shape of the bar column heads with socket pins and spring lock enables the bars to be changed quickly.

Assembly

Place the 2 cross-sleepers on the floor with the levers of the drive mechanism facing outwards and the feet pointing upwards and place the longitudinal sleepers between them with the open side up.

Tip: Place the sleepers on a mat to avoid scratches on the surface.
Loosen the pre-assembled M12 screws and set them aside with the washer and position the sleepers so that the hole matches the thread.

Fix the position of the sleepers with the screws by hand-tightening them. Align the sleepers so that the cross sleepers are parallel to each other and at right angles with the longitudinal sleepers.
Then tighten the screws with a wrench or nut

Afterwards turn the assembled steel structure by 180 °. Unscrew the M12 screws from the cross-sill tops.

For further assembly it is recommended to raise the frame on one side.

Position a large pillar on the raised threshold according to the hole pattern and hold the pillar firmly.

Fix the column by tightening the screws with a 19 mm socket and a 19 mm key.

Then fix the column additionally with a safety rod.

Now position the small pillar on the cross sleeper so that the hole pattern of the column and sleepers match. Tighten the screws.

Now install the width adjustment between the columns with the handle pointing downwards.

Now lift the side to remove the elevation. Repeat building the pillars on the other side. To be on the safe side, the already assembled side should be held by one per-son.
Finally, insert the bars and secure them with the spring split pins.

Warning:

• Check all tension cables and floor anchors for proper function and stability before using the apparatus.

• In order to reduce the risk of injury and to assure secure functioning of the apparatus, rules mentioned below are to be strictly followed:

• Use this equipment only under the supervision of a trained and qualified instructor.

• Check this equipment for proper stability before each training, use it only in perfect technical conditions.

• Always check the apparatus for its correct installation, particularly for the anchorage, tensioning and locks before each use.

• If there are any doubts, do not use the apparatus and get a professional check for the apparatus.
  This gymnastics equipment may only be used with functional mats.

• Do not use this apparatus if in doubt concerning suitability of mats and get

• them checked by a professional service.

• Please consider your own limits and the restrictions of this gymnastics apparatus, while using it.

• Obstructive items or persons in close proximity of the apparatus are not allowed.

• Provide appropriate safety zones in the surroundings of the apparatus.

• Never use the apparatus under influence of alcohol, medication or drugs.

• Pregnant women or persons with health issues should not use this apparatus.

General advise:
The life period of gymnastic equipment and mats is limited. Also materials wear off after a certain period of time. Please check all parts, which are the subject to severe wear and tear, at least once in 3 months. This is mainly relevant for the security of adjustable parts and mechanisms, e.g. rails, bars, rings. Replace any worn off, defective and missing parts. If there are any doubts, ask for the advice of a specialist. For security reasons, we suggest to perform the maintenance of gymnastics equipment and mats by a specialist once a year! We also recommend the check of floor anchorage by some authorized specialist. In case of damage, e.g. a torn anchor, Bänfer assumes no liability!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>