babyalarm 33499000 Digital Baby Monitor User Manual
- June 9, 2024
- babyalarm
Table of Contents
babyalarm 33499000 Digital Baby Monitor
Declaration of conformity:
Impulse A/S hereby decdares that this item conforms Directive 2014/53/EU (RED)
and the other relevant regulations stipulated in Directive 2014/53/EU.
Important Congratulations
Congratulations on your purchase! Please read the instructions thoroughly before using the monitor system and keep it for future reference.
Safety Precautions
- When using this unit, basic Safety Precautions should always be followed to reduce the risk of fire, electric shock, or personal injury.
- Read and understand allinstructions.
- Follow all warnings and instructions marked on this unit or mentioned in this operation instruction.
- Do not use liquid or aerosol cleaners. Use a damp cloth for cleaning
- Do not use this unit near water such as bathtub, shower or pool. Immersion of this unit in water could cause an electrical shock.
- Place the unit securely on a stable surface. Serious damage and/or injury may occur if the unit falls.
- Do not cover slots and openings on the unit. They are provided for ventilation and protection against overheating.
- Install the unit where no one can step or trip on the cord.
- Never spill any liquid on the unit. This may result in the risk of fire or electric shock.
- To reduce the risk of electric shock, do not disassemble this unit. Take the unit to authorized service center or qualified technician when service or repair work is required.
- Opening or removing covers may expose you to dangerous voltages or other risks. Incorrect reassembly can cause electric shock when the unit is subsequently used.
- Do not expose the unit to extreme temperatures such as areas near a hot radiator or stove or in a hot car.
- Do not place lighted objects such as candles, cigarettes on the unit.
Caution:
- This product cannot replace responsible adult supervision.
- This Baby Monitor is intended as an aid. Do not use it as a medical monitor or a substitute for responsible and proper adult supervision.
- Make sure the Parent Unit and adaptor cables are always out of child’s reach. Do not place the
- Baby Unit inside the baby’s crib or playpen!
Warning:
To prevent the risk of fire or electrical shock, do not expose this unit to
rain or any type of moisture.
Introduction
Overview of Parent Unit
Overview of Baby Unit
Operation Instruction
Parent Unit
-
Power ON/OFF
-
Insert 3 AAA batteries or connect the Parent Unit with DC adaptor. The unit will be switched on automatically.
-
LCD will be fully displayed with backlight on about 5 seconds
-
Power OFF by pressing POWER””until no display on LCD.
-
Pairing
-
Press and hold the button “”and””on Parent Unit until the first BLUE LED indicator on top is flashing, then press and hold the button “”and “+”at the same time on Baby Unit, units are paired when “DI..” sound was heard on both units.
-
While units are not paired, either Baby Unit is powered OFF or lost signal, Parent Unit will sound “DI, DI, DI..and the signal T keeps flashing.
-
Volume Adjustment
-
Press the button < on the left for decreasing volume level, 5 levels in total, each press comes with the sound “DI”. You will hear “DIDI” when the volume is decreasing to a minimum.
-
Press the button > on the right for increasing the volume level, 5 levels in total, each press comes with the sound “DI'”. You will hear “DI” when the volume is increased to a maximum.
-
VOX ON/OFF
-
Press the key “ ” on the left and the button on the right at the same time to switch ON VOX, till “VOX” displays on the screen.
-
Press the key “ ” on the left and the button on right at the same time to switch OFF VOx, till “VOX” disappear on the screen.
-
When VOX is ON, the sound of the Baby Unit will activate Parent Unit along with the LCD screen ON. When sound is lower than the sensitivity of the Baby Unit fora while,
-
Parent Unit switches to STANDBY mode automatically. The monitor function is always ON while VOX is OFF.
-
When Parent Unit & Baby Unit are connected with an adaptor, the VOX function will be off automatically.
-
The user needs to activate VOX again.
-
Music Function
-
Press the music button for about 2 seconds to switch the music ON, until LCD displays and the music plays. Meanwhile, the song number (010-060) will be shown in the temperature area. When the music stops playing, If no operation on the music button, it will be switched back to the temperature display
-
Press the music button for about 2 seconds to switch music OFF; until disappear on LCD and the music stops.
-
When the music plays, quickly press for the next lullaby. There is a total of 6 lullabies.
-
When music is playing, press the talk button to stop the music and talk to your baby.
-
Music function exit automatically.
-
Night Light Function
-
Press the night light button to switch ON the night light on Baby Unit, and will be displayed on the left bottom on LCD.
-
Press the night light button to switch OFF the night light on Baby Unit, and will be disappeared on LCD.
-
Talk Back Function
-
Press the button on left of the Parent Unit to talk to the Baby Unit.
-
Press and hold the button to maintain your conversation.
-
Release the button when finished talking.
-
Talk volume can be adjusted by pressing the button”+” or”-“on Baby Unit.
NOTE : During talking, Parent Unit is not available to receive any sound from Baby Unit. (Monitor function is OFF) -
Temperature Display
-
The temperature will display automatically on the middle of LCD when power ON for both units & pairing successfully.
-
If Baby Unit is OFF or lost signal, Parent Unit can’t display real-time temperature.
NOTE : Temperature is shown in Celcius °C by factory default setting. -
Low Battery Indicator
-
When the unit is low on battery, the power indicator will be flashing and comes with sound alert “BI BI…”to remind charging or replace with new batteries.
-
Battery Charging
-
Open the battery compartment, using a small screwdriver.
-
Insert 3 AAA alkaline batteries into the Parent Unit.
-
Re-attach the battery compartment lid, using a small screwdriver.
-
There are two modes of power supply, one is battery power supply, the other is switching mode power supply.
Battery Power Supply:
The unit can use 3 * AAA alkaline batteries or rechargeable batteries (N-MH).
Switching mode power supply
Use only the DC adaptors supplied and plug into standard household electrical
outlet, batteries are charging while battery icon displayed as right.
When powered by switching power mode, you don’t have to remove the batteries.
Non-rechargeable batteries (such as Alkaline batteries) will not be charged
for safety precaution.
If 3 AAA alkaline batteries are used, unit will automatically switch to
switching mode power supply and no harm done to the battery. If rechargeable
batteries (Ni-MH) are used, the adaptor will power the product as well as
charge
Warning : Danger of explosion if batteries are not placed correctly.
Dispose of used batteries according to the instructions. Replace only with the
same or equivalent type.
Out of Range Alert (Only for Parent Unit)
The 5 LED indicators will flash and comes with sound alert “BI, BI…” when
below circumstances happen.
- Out of range.
- Baby Unit lost signal.
- Baby Unit power OFF.
Baby Unit
-
Power ON/OFF
-
Insert 3 AAA batteries or connect the Baby Unit with the DC adaptor.
-
Press the button to switch ON until LED indicator turns GREEN.
-
Press the button to switch OFF until LED indicator OFF and comes with “Bl” sound alert.
-
Pairing
-
After the pairing mode is ON of Parent, press”0″and”+” to paired with Parent Unit.
-
Power indicator turns GREEN and comes with “Bl’ sound when pair successfully.
-
When Baby Unit fails to pair, the power indicator will keep flashing in GREEN.
-
Volume Adjustment
-
Press the button”+”to increase volume level, 5 levels in total, comes with “BI. BI” when volume has reached maximum.
-
Press the button””to decrease volume level; 5 levels in total, comes with “BI. Bl” when volume is down to minimum.
-
Music Function
-
Press the button Ja for about 2 seconds to switch ON music.
-
Press the button Jd for about 2 seconds to switch OFF music.
-
Quick press the button Jd for next lullaby, 6 lullabies in total.
-
Music volume can be adjusted by pressing “+”
-
Room Temperature Sensor
-
The temperature at the baby unit will be transmitted to the parent unit after 30 seconds when power is switched on.
-
The temperature is influenced by the outer environment and will change accordingly.
-
Please keep the temperature sensor on position.
-
VOX Function
-
Under connected conditions, Baby Unit is always under audio monitoring by Parent Unit.
-
When sound is detected & reached a certain sensitivity level, the Parent unit LCD will be powered on automatically.
(This is not a page function. It is a VOX function. Paging is call tones transmitted to parent unit) -
Night Light Function
-
Press night light buttonto switch the night light ON.
-
Press night light buttonto switch the night light OFF.
-
When operate the night light button on Parent Unit, it will need to wait about 3 seconds to operate on Baby Unit.
-
Low Battery Indicator
-
When the unit is in low battery, the power indicator will be flashing in GREEN.
-
Battery Placement
-
Open the battery compartment with a small screwdriver.
-
Insert 3 AAA alkaline batteries into the Baby Unit.
-
Re-attach the battery compartment lid, using a small screwdriver.
NOTE :There are two modes of power supply, one is battery power supply, the other is switching mode power supply.
Battery Power Supply:
The unit uses 3 * AAA alkaline batteries.
Switching mode power supply
- Use only the DC adaptors supplied and plug into standard household electrical outlet.
- When powered by switching power mode, you don’t have to take out the battery.
- IF AAA alkaline battery is inside, it will automatically switch to switching mode power supply and no harm done to the battery.
- Baby Unit cannot charge rechargeable batteries.
Warning : Danger of explosion if bateries are not placed correctly. Dispose of used batteries according to the instructions. Replace only with the same or equivalent type.
Troubleshooting
Technical Specification
What is in Pack
- 1x Parent Unit
- 1x Baby Unit
- 2x DC adaptors
- 2x USB cables
- 3x Ni-MH rechargeable battery
Service
If the product mafunctions, please do not hesitate to contact the sales outlet
where you bought the babyalarm. If they are unable to help you, please use our
internet service at impulse.dk
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>