emerio CH-106492 Convector Heater Instruction Manual
- June 4, 2024
- emerio
Table of Contents
CH-106492
Convector heater
Instruction Manual
Important: Read this instruction fully before using the heater; retain these
instructions for future reference.
This product is only suitable for well-insulated spaces or occasional use.
ASSEMBLY OF THE HEATER
Before using the heater, the feet (supplied separately in the box) must be fitted to the unit. These are to be attached to the base of the heater using the 4 self-tapping screws provided, taking care to ensure that they are located correctly in the bottom ends of the heater side moldings.
SAFETY INSTRUCTIONS (READ BEFORE OPERATING THE HEATER)
- Read and save these instructions. Attention: pictures in the instruction manual are for reference only.
- This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved.
- Children shall not play with the appliance.
- Cleaning and user maintenance shall not be made by children without supervision.
- Children of less than 3 years should be kept away unless continuously supervised.
- Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance.
- CAUTION — Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present.
- Do not use this heater if it has been dropped.
- Do not use it if there are visible signs of damage to the heater.
- Use this heater on a horizontal and stable surface.
- WARNING: Do not use this heater in small rooms when they are occupied by persons not capable of leaving the room on their own unless constant supervision is provided.
- WARNING: To reduce the risk of fire, keep textiles, curtains, or any other flammable material at a minimum distance of 1 m from the air outlet.
- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualified persons in order to avoid a hazard.
- This appliance is intended to be used in households and similar applications.
- Do not use the heater unless the feet are correctly attached.
- Ensure that the power supply is plugged in accordance with the rating label on the heater; the socket must be earthed.
- Keep the mains lead away from the hot body of the heater.
- The heater is not intended for use in bathrooms, laundry areas, or similar indoor locations. Never place the heater where it may fall into a bathtub or any other water container.
- Do not use outdoors.
- Do not cover or obstruct any of the heat outlet grilles or the air intake openings of the heater.
- Do not place the heater on carpets with a very deep pile.
- Always ensure that the heater is placed on a firm level surface. Ensure that the heater is not positioned close to curtains or furniture as this could create a fire hazard.
- The heater must not be located immediately below a socket outlet.
- Do not insert any object through the heat outlet or air intake grilles of the heater.
- Do not use the heater in areas where flammable liquids are stored or where flammable fumes may be present.
- Particular care should be taken when the heater is situated in areas occupied by children or disabled persons.
- Always unplug the heater when moving it from one location to another.
- Do not use the heater if the power cord is damaged.
- Do not use this heater in the immediate surroundings of a bath, a shower, or a swimming pool.
- WARNING: In order to avoid overheating, do not cover the heater.
- The appliance should not be operated by means of an external timer switch or by means of a separate system with remote control not originally belonging to this appliance.
- This heating device is not suitable for assembling vehicles and machines.
Means “DO NOT COVER “.
PARTS DESCRIPTION
- Air outlet
- Power switch (750W; 1250W; 2000W)
- Thermostat
- Air inlet
- Feet
OPERATION OF THE HEATER
Note: When the heater is turned on for the first time, or when it is turned on after a longer period of storage, it is normal that the heater may emit some smell and fumes. This will disappear when the heater has been on for a short while.
- Set the thermostat to the minimum position and insert the plug into the power supply.
- Turn on the power switch: low heating = 750W; medium heating = 1250W, high heating = 2000W (Both switches are on). When the power switch is on, the indicator light on the switch will illuminate.
- Turn the thermostat knob in a clockwise direction to the max position.
- Once the room temperature has reached the desired value, turn the thermostat knob slowly in an anti-clockwise direction until you hear a “click” sound; this is the set temperature.
- The appliance will automatically maintain the set temperature. It will switch on when the room temperature is below the setting, and switch off if it is above the setting.
Caution: The heater will remain hot for some time after it is turned off. Handle with care.
OVERHEAT PROTECTION
This heater is protected with an overheat protection that switches off the appliance automatically in case of overheating, e.g. due to the total or partial obstruction of the grids. In this case, unplug the appliance, wait about 30 minutes for it to cool, and remove the object which is obstructing the grids. Then switch it back on as described above. The appliance should operate normally. Should the problem persist, please contact the nearest customer service?
CLEANING THE HEATER
Always unplug the heater from the wall socket and allow it to cool down
completely before cleaning. Clean the outside of the heater by wiping it with
a damp cloth and with a dry cloth. Do not use any detergents or abrasives and
do not allow any water to penetrate the heater.
STORING THE HEATER
When the heater is not used for a long time it should be protected from dust
and stored in a clean dry place.
TECHNICAL DATA
Operating voltage: 220-240V ~ 50-60Hz
Power consumption: 1800-2000W
GUARANTEE AND CUSTOMER SERVICE
Before delivery, our devices are subjected to rigorous quality control. If,
despite all care, the damage has occurred during production or transportation,
please return the device to your dealer. In addition to statutory legal
rights, the purchaser has an option to claim under the terms of the following
guarantee:
For the purchased device we provide 2 years guarantee, commencing from the day
of sale. If you have a defective product, you can directly go back to the
point of purchase.
Defects that arise due to improper handling of the device and malfunctions due
to interventions and repairs by third parties or the fitting of non-original
parts are not covered by this guarantee. Always keep your receipt, without the
receipt you can’t claim any form of warranty. Damage caused by not following
the instruction manual will lead to a void of warranty, if this results in
consequential damages then we will not be liable.
Neither can we hold responsible for material damage or personal injury caused
by improper use or if the instruction manual is not properly executed. Damage
to accessories does not mean free replacement of the whole appliance. In such
case please contact our service department. Broken glass or the breakage of
plastic parts is always subject to a charge. Defects to consumables or parts
subjected to wearing, as well as cleaning, maintenance, or the replacement of
said parts are not covered by the warranty and are to be paid.
ENVIRONMENT-FRIENDLY DISPOSAL
Recycling – European Directive 2012/19/EU
This marking indicates that this product should not be disposed of with other
household wastes. To prevent possible harm to the environment or human health
from uncontrolled waste disposal, recycle it responsibly to promote the
sustainable reuse of material resources. To return your used device, please
use the return and collection systems or contact the retailer where the
product was purchased.
They can take this product for environmentally safe recycling.
ERP information
Supplier: Emerio B.V.
Ludwig 115
2031 CC Haarlem
The Netherlands
Declare that the product detailed below:
Information requirements for electric local space heaters
Model identifier(s):|
---|---
Item| Symbol| Value| Unit| Item| Unit
Heat output| | | | Type of heat input, for electric storage local space
heaters only (select one)
Nominal heat output| Pnom| 1.8-2.0| kW| manual heat charge control, with
integrated thermostat| No
Minimum heat output
(indicative)| Pmin| 0.75| kW| manual heat charge control with room
and/or outdoor temperature feedback| No
Maximum continuous heat output| Pmax,c| 2.00| kW| electronic heat charge
control with room and/or outdoor temperature feedback| No
Auxiliary electricity consumption| | | | fan-assisted heat output| No
At nominal heat output| elmax| N/A| kW| Type of heat output/room temperature
control (select one)
At minimum heat output| elmm| N/A| kW| single stage heat output and no room
temperature control| No
In standby mode| elss| 0| kW| Two or more manual stages, no room temperature
control| No
| | | | with mechanic thermostat room temperature control| Yes
| | | | with electronic room temperature control| No
| | | | electronic room temperature control plus day timer| No
| | | | electronic room temperature control plus week timer| No
| | | | Other control options (multiple selections possible)
| | | | room temperature control, with presence detection| No
| | | | room temperature control, with open window detection| No
| | | | with distance control option| No
| | | | with adaptive start control| No
---|---|---|---|---|---
| | | | with working time limitation| No
| | | | with black bulb sensor| No
Contact details| Emerio B.V.
Oudeweg 115
2031 CC Haarlem The Netherlands
Satisfies the requirement of the Council Directives:
COMMISSION REGULATION (EU) No 2015/1188 of 28 April 2015 and Amending
COMMISSION REGULATION (EU) 2016/2282 implementing Directive 2009/125/EC of the
European Parliament and of the Council with regard to ecodesign requirements
for local space heaters
Regarding information for consumers on how to install, use and maintain the
product, WEEE information, please check the instruction manual provided with
the packaging.
Emerio B.V.
Oudeweg 115
2031 CC Haarlem
The Netherlands
Customer service:
T: +31 (0) 23 3034369
www.emerio.eu/service
Kundeninformation:
T: +49 (0) 3222 1097 600
www.emerio.eu/service
Klantenservice:
T: +31 (0) 23 3034369
www.emerio.eu/service