Patio Boss NX-1500R Electric Outdoor Heater User Guide

NX-1500R Electric Outdoor Heater
User Guide

Thank you for choosing our Electnc Outdoor Heater. This user manual will provide you with valuable information necessary for the proper care and maintenance of your new product.
Please take a few moments to thoroughly read the instructions and familiarize yourself with all the operational aspects of your new product.

INTRODUCTION

Plese tale a few minutes to read this manual carefully.
Proper maintenance and operation of this machine prove better grvice

SAFETY WARNING

READ ALL INSTRUCTIONS BEFORE ATTEMPTING TO OPERATE THIS UNIT. KEEP THE ASSEMBLY INSTRUCTIONS FOR FUTURE REFERENCE. KEEP THE ASSEMBLY INSTRUCTIONS FOR FUTURE REFERENCE. KEEP THE ORIGINAL PACKAGING FOR USE WHEN STORING THE HEATER DURING EXTENDED PERIODS OF NON-USE.

1. Read all instructions before using this unit.
2. Do not leave this unit unattended when in use
3. This heater will get hot when in use. Do not touch hot surfaces
4. Some parts of this product can become very hot and cause burns. Particular attention has to be given when children and vulnerable people are present.
5. Do not move the unit when in use. Wart until the heater is completely cool before moving and check that it has been unplugged from the power supply
6. Posdion the unit at least lm away from highly combustible materials such as furniture, trees. leaves. dry grass and bushes
7. The heater must be a minimum of 1.8m(6 feet) away from the ground and a minimum of 0.7m (2.5 feet) away from the cm:mg of a building or overhanging items.
8. The heater must not face with the heating element pointing upwards towards a ceiling. The heater element must be facing the area it is to heat.
9. In order to avoid overheating do not cover the heater, It is not for drying clothes.
10. Keep children and pets at a safe distance from the unit
11. This appliance can be used by children aged horn 8 years and above and persons with reduced physical, sensor/ or mental capabilities or lack of experience and kncmlecige if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
12. Children shall not play vigh the appliance Cleaning and user maintenance shall not be made by children without supervision
13. Do not operate the heater if any signs of damage or malfunction rnanrfest
14. Do not attempt to repair or adjust any electrical or mechanical functions on this unit. The unit does not contain any user serviceable parts. Only a qualified electrician  should perform servicing or repairs. Attempting to repair the unit yourself will void your warranty. 115) If the power cable is damaged. it must be replaced by the  manufacturer. its service agent or similarly qualified persons in order to avoid a hazard.
15. Do not handle the element with bare hands. If it is inadvertently touched. remove finger marks with a soft cloth and methylated spirits or alcohol, othenwse the marks will bum into the element causing premature heater failure.
16. Do not replace or attempt to replace the element in this product
17. This product is suitable for indoor and outdoor use. Do not use this heater in the immediate surroundings of a bath_ shower or swimming pool.
18. Do not wind the power cable around the unit
19. This product must not be left outdoors exposed to the elements for long periods of time.
20. Do not touch the plug with wet or damp handsDo not run the power cable under carpeting.
21. Do not cover the power cable with rugs, or similar coverings. Arrange the power cable away from foot traffic and where It will not be tripped over.
22. Do not insert or allow foreign objects to enter any ventilation or opening on the heater, as this may result in electric shock, fire or damage to the heater.
23. To prevent a possible fire. do not block the air vents.
24.  A heater has hot and arcing or sparking parts inside.
25. Do not use in areas where petrol, paint explosive andror flammable liquids are used or stored Keep unit away from heated surfaces and open flames.
26. Where possible, avoid the use of an extension cable as this may overheat and cause a fire. However, if you have to use an extension cable. ensure it is suitable for the purpose. has been tested for outdoor use and preferably has an RCD device fitted or attached.
27. Always ensure the heater b plugged unto a suitable socket. one that is tested for outdoor use
28. To disconnect heater, turn controls to OFF, then remove plug from socket Do not unplug by pulling on the power cable
29. Always unplug the unit and ensure the and is completely cold before moving. cleaning or stonng
30. This heater is intended for domestic use orVy and should not be used commercially for contract purposes Any arternative use, not recommended by the manufacturer may result in fire, electric shock. or injury to persons.
31. The use of attachments on the heater is not recommended
32. Warning: This heater is not equipped with a device to control the room temperature Do not use this heater in small rooms when occupred by persons not capable of leaving a room on their awn. unless constant supervision is provided
33. Check exterior walls for areas of damage before installing the heater
34. Always use on a dry. suitably strong, stable. flat and level surface.
35. Check exterior walls for communication and electrical cables and pipelines Should any service Ines be present in the immediate vicinity do not install your heater, find an alternative location to install this product
36. Do not position directly above or below an actncal socket
37. Do not remove any of the warning stickers or signs from the product.

PRODUCT CONTENTS

NUIT DIAGRAM

HEATER BODY COMPONENTS

1. Front aluminum mot
2. Lilt housing
3. LAM docorsove cow
4. Beck alts-nloum cos
5. Pining tubs
6. H-PaMir cord
7. Mr housing
8. Algot docorstve cover —
9. LED *spinet
10. Prolecoon gnii
11. Oscorsinal support

HEATER HOLDER COMPONENTS

1. Cross bass
2. Bottom Its
3. Ftroct screw
4. TX tube
5. Moulting bracket
6. MounIng backs.

SPECIFICATION

INSTALLATION INSTRUCTIONS

Heater Holder installation Instruction

1. Assemble the Floor Stand. Unscrewing and removing the Top Plate from the Base. and placing the Legs into each of the slots.
   Attention TM Wigs will not skis completely Into the slots Forcing thern to do so may damage tie pieces This situation is correct as the picture.

2. Insert the telescoping post into the hole of the base and tighten with the top plate
   

3. Slide the large and small card clips over their respective sides of the telescoping post and tighten the screws to keep them in the location of your choice.

4. Use 2 M6′ 14 and 2 Wing nuts to combine top of bracket I i long end) to the bottom of bracket 2 (short end)

5. Use 2 M6’37 screws and 2 acorn nuts to install the front of bracket 2 (long end) to the rear of the telescoping post.

STORAGE

Store the heater in a cool, dry location when not in use. To prevent dust and dirt build-up, use the original packaging to repack the unit.
This symbol on the product or its packaging indicates that the appliance cannot be treated as normal domestic trash. but must be handed in at a collection point for recycling electric and electronic appliances Your contribution to the correct disposal to the product protects the environment and the health of your fellow men Health and the environment are endangered by incorrect disposal Further information about recycling of this product can be obtained from your local tcrren hall. your refuse collection service. or in the store at which you bought the product.

E-mail: service@apatioboss.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>