VINTAGE INDUSTRIAL SDH-SW5IND-BLK Classic Top Mount Installation Guide

VINTAGE INDUSTRIAL SDH-SW5IND-BLK Classic Top Mount

MODEL No. SDH-SW5IND- BLK

TOOLS REQUIRED

• Plumb Line
• Pencil
• Phillips Head Screwdriver
• 5.5mm Drill Bit
• 8mm Drill Bit
• Wrench
• Level
• Tape Measure
• Power Drill

INCLUDED IN KIT

A

| Door Roller Hardware| x2
---|---|---

B

| 78″ Rail| x1

C

| Door Stop| x2

D

| M8x30 Wall Anchor| x5

E

| M8x60 Bolt + Washer| x5

F

| M8x90 Bolt| x4

G

| Anti-Jump Disk + Mounting Screw| x2

H

| Wall Bracket| x5

I

| Routed Floor Guide| x1

J

| Floor Anchor| x2

K

| ST4.2×35 Screw| x2

L

| 2.5mm Allen Key| x1

DIMENSION

NOTES

Minimum door overlap on guide is 2″

To obtain maximum weight capacity, all fasteners must be mounted into solid wood studs or wall blocking or mounted to a header board.

Consult a structural engineer if you have questions about what type of wall blocking is required.

INSTALLATION INSTRUCTIONS

1. Find the centerline of the track. Using a level, mark a horizontal line twice the door width long. Mark the bracket screw locations into the wall blocking. Attach the wall portion of the brackets as shown.

2. Attach the rail to the wall brackets using a wrench to fasten the bolts as shown.

3. Drill holes in the top of the door 5-1/4″ from the edge as pictured to accommodate the door rollers. The bottom of the door should be routed at this time in order to accept the floor guide.

4. Attach the anti-jump disks to the tops of the door.

5. Attach the door to the rails making sure that the anti-jump disks are engaged to avoid a serious accident.

6. Plumb the door and mark the positions of the floor guides. Mount the floor guides to the floor.

7. Adjust the door stops accordingly using the provided 2.5mm Allen key.

Architectural Products by Outwater assumes no liability for improper installation.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>