DGSHAPE CA-DK2 Denture Creation Kit User Manual
- June 4, 2024
- DGSHAPE
Table of Contents
CA-DK2 Denture Creation Kit
DWX-520/DWX-52DC/DWX-52DCi
Thank you very much for purchasing this product.
Use this kit to create dentures using room-temperature polymerizing resin or
heated polymerizing resin. There are two methods for each type of resin: the
denture base cutting method in which the resin is polymerized before the
denture base is cut and the artificial teeth are affixed and the complete
denture (full denture) cutting method in which the mold for the artificial
teeth is cut and arranged and the resin is polymerized before the complete
denture (full denture) is cut. Use this product as shown below to match the
resin used and the work method.
For details on the work methods, see the User’s Manual, which can be viewed
and downloaded from the following URL.
Room-temperature polymerizing resin
https://downloadcenter.rolanddg.com/CA-DK2
- Denture base cutting method: Polymerize the resin, and then cut the denture base and affix the artificial teeth.
- Complete denture (full denture) cutting method: Cut and arrange the mold for the artificial teeth, polymerize the resin, and then cut the complete denture (full denture).
Heated polymerizing resin
- Denture base cutting method: Polymerize the resin, and then cut the denture base and affix the artificial teeth.
- Complete denture (full denture) cutting method: Cut and arrange the mold for the artificial teeth, polymerize the resin, and then cut the complete denture (full denture).
Company names and product names are trademarks or registered trademarks of their respective holders.
Copyright © 2021 DGSHAPE Corporation
R2-211215
http://www.dgshape.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>