ZANUSSI ZFP216W Hood Telescopic User Manual
- June 8, 2024
- Zanussi
Table of Contents
ZANUSSI ZFP216W Hood Telescopic
SAFETY INFORMATION AND INSTALLATION
WARNING! Refer to the separate Installation Instructions booklet for Safety Information and Installation. Read carefully the Safety chapters before any use or maintenance of the appliance.
PRODUCT DESCRIPTION
CONTROL PANEL OVERVIEW
| ****
Function
| ****
Description
---|---|---
1| First Speed| The fan switches to first speed level.
2| Second Speed| The fan switches to second speed level.
3| Third Speed| The fan switches to third speed level.
4| Lamp| Turns the lights on and off.
USING THE HOOD
Check the recommended speed according to the table below.
| 1 | While heating up food, cooking with covered pots. |
|---|---|
| 2 | While cooking with covered pots on multiple cooking zones or burners, |
gentle frying.
3 While boiling and frying big quantities of food without a lid, cooking on multiple cooking zones or burners.
NOTE
It is recommended to leave the hood operating for approximately 15 minutes after cooking.
To operate the hood:
- Pull out the drawer of the hood more than 5 cm.
- To activate the function press the 0 1 button
- If needed, change the speed by pressing the desired button.
NOTE
The hood’s light works independently of other hood functions. To illuminate the cooking surface press the light button. Closing the drawer has no effect on the hood light.
To turn off the fan press 0 1 or close the hood drawer
NOTE
The hood remembers last setting of fan speed on closing the drawer. The hood will operate on this fan speed level when drawer is pulled out again.
CARE AND CLEANING
NOTES ON CLEANING
CLEANING THE GREASE FILTER
Filters are mounted with the use of clips and pins on the opposite side.
To clean the filter:
-
Press the handle of the mounting clip on the filter panel underneath the hood (1).
-
Slightly tilt the front of the filter downwards (2), then pull.
Repeat the first two steps for all filters. -
Clean the filters using a sponge with non abrasive detergents or in a dishwasher.
The dishwasher must be set to a low temperature and a short cycle. The grease filter may discolour, it has no influence on the performance of the appliance. -
To mount the filters back follow the first two steps in reverse order. Repeat the steps for all filters if applicable.
REPLACING THE CHARCOAL FILTER
WARNING! The charcoal filter is NON-washable! The filter cannot be regenerated!
To replace the charcoal filter:
-
Remove the grease filters from the appliance.
Refer to “Cleaning the grease filter” in this chapter. -
Turn the filter counterclockwise (1) and then pull (2).
To mount the filters back follow the steps in reverse order. In any case, it is necessary to replace the filters at least every four months.
REPLACING THE LAMP
This appliance is supplied with a LED lamp and a separate control gear (LED
driver). These parts can be replaced by a technician only. In case of any
malfunction refer to “Service” in the “Safety Instructions” chapter.
ENVIRONMENTAL CONCERNS
Recycle materials with the symbol . Put the packaging in relevant containers to recycle it. Help protect the environment and human health by recycling waste of electrical and electronic appliances. Do not dispose of appliances marked with the symbol of household waste. Return the product to your local recycling facility or contact your municipal office.
VISIT OUR WEBSITE TO:
Get usage advice, brochures, trouble shooter, service and repair information:
www.zanussi.com/support
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>