Pukonger ST-Q4 5 In 1 Charging Station User Guide
- June 8, 2024
- Pukonger
Table of Contents
5 inl Charging Station
Model : ST— Q4
Version: 1.03
Power Parameter
Adapter
Input: AC 100-240V, 1A (Max)
Output: DC 12V 4A(Max)
Charging Station
Input: DC 12V 4A(Max)
Output: Earphone Charger: DC 5V1A(Max)
2 in 1 Phone Cable: DC 5V4A(Max)
Watch Wireless Charger: 5W(Max)
Phone Wireless Charger: 10W(Max), 7.5W(Max), 5W(Max)
PART LIST
Base * 1
Watch Charger 1 Phone Support 1
Wall Charger (Adapter) * 1
2 in 1 Phone Cable * 1
INSTALLATION NOTES
1 Insert the watch charger into the base obliquely, then press it down.
2 Insert the phone support into the base vertically.
3 Adjust the phone support to the angle you want.
4 Put your watch on the watch charger.
With forceful magnetic attraction, it can automatically adjust the height to fit watch in different sizes for getting faster charging.
5 Put your AirPods on the AirPods holder.
6 Insert the 2-in-1 phone cable into the base, and sort out 2 cables on the silicone hole.
7 Choose the right cable to charge.
WARM TIPS
1 Please ONLY use the original adapter that comes with the product!
2 Keep in mind to charge your device before it runs out of power, otherwise it will shorten the working life of your devices.
3 Reach us by your Amazon order detail page (select “order” “sold by” or “contact seller”) or contact us via email for warranty or customer services about it.
Service Email:
Tina_service@Outlook.com
**** 1 Year Warranty and Dedicated Customer Service.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment. NOTE: This equipment
has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum distance between 20cm the radiator your body: Use only the supplied antenna.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>