National Lighting DOCK-1600 Series Scepter User Guide
- June 9, 2024
- National Lighting
Table of Contents
National Lighting DOCK-1600 Series Scepter
WARNING
To reduce the risk of fire, electric shock or injury to persons:
- Indoor use only
- Do not use with extension cord(s)
- Do not plug a device or devices into receptacles that exceed a total of 9.7A (1164 watts)
- Do not open or attempt to open the unit for any reason
PRODUCT OVERVIEW
Specifications
Specifications: 3 x Qi wireless rapid chargers,
3 x Tamper-resistant AC receptacles,
2 x USB Type-A charging ports,
1 x 30W USB Type-C charging port,
1 x 60W USB Type-C charging port.
- Supports USB PD3.0 charging standard
- Support PPS charging standard
- Support QC2.0 / 3.0 charging standard
- 5.0 Support USB DCP BC1.2 charging standard
- Support Apple 5W / 10W / 12W USB charging standard
- Support AFC charging standard
- Supports FCP charging standard
- Storable temperature (non-operating): -30 °C to 70 °C Typical value: 25 °C
- Operating temperature Limits: -20 °C to 40 °C Typical value: 25 °C
- Storage Humidity (non-operating): 5% to 90% RH (Non condensation)
- Operating Humidity Limits: 10% to 90% RH (Non condensation)
- Storage Altitude (non-operating): 0 to +2000m above the sea level
- Operating Altitude (non-operating): 0 to +2000m above the sea level
USB output charging can reach 60W maximum.
Wireless charging module can wirelessly charge mobile phones at a distance of
0-6mm. The maximum power can reach 10W
ISED RSS Warning/ISED RF Exposure Statement
ISED RSS Warning:
This device complies with Innovation, Science and Economic Development Canada
licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
ISED RF exposure statement:
This equipment complies with ISED radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body. This transmitter must
not be co-located or operating in conjunction with any other antenna or
transmitter.
FCC Statement:
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
