Bullhorn Monitoring 6267210001 RM5 I Oil and Gas Asset Monitor User Guide
- June 4, 2024
- Bullhorn Monitoring
Table of Contents
RM5 I Oil and Gas Asset Monitor
User Guide
Getting Started
This guide provides an overview of the RM5 I/O4 unit.
RM5 I/O4 Overview
The RM5 I/O4 unit is used to monitor up to 4 analog voltage and 2 digital
inputs. RM5 I/O4 also includes a relay control output voltage and interface
ports to daisy chain additional RM5 I/O4 units. RM5 I/O4 is powered by an
external 12Vdc voltage source. Dome Status LED will illuminate when power is
applied to the RM5 I/O4 unit.
The Bluetooth interface is activated by placing a magnet near the right side
of RM5 I/O4 units. Blue LED will illuminate to indicate Bluetooth is active.
FCC Statements and Warning:
This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. In order to comply
with FCC RF Exposure requirements, this device must be installed to provide at
least 20cm separation from the human body at all times.
Industry Canada Statements and Warnings
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science, and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
In order to comply with ISED RF Exposure requirements, this device must be installed to provide at least 20cm separation from the human body at all times.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>