AMERIPHONE AM-DX Clarity Alertmaster Baby Sound Monitor User Manual
- June 3, 2024
- AMERIPHONE
Table of Contents
AMERIPHONE AM-DX Clarity Alertmaster Baby Sound Monitor User Manual
INSTALLATION
PLACEMENT
- Place the AM-BX with MIC pointing toward and as close to the baby as possible, but no more than 5 feet away.
- Place the AM-AX and AM-DX with MIC pointing toward and within 6 inches from he audio alarm device or door chime/ intercom respectively.
For installation on textured ceilings, screw a standard light switch cover, readily available from your local hard-ware store, on ceiling and apply the velcro ® strips to the plate instead of directly on ceiling.
BATTERY AND OPERATION TESTS
Check or change the battery every six months to make sure it is properly charged .
AM-AX Press the Test button on your audio alarm device. Check that the Alarm function comes on at the Alertmaster console after 12 seconds.
AM-BX Make loud noise continuously for 5 seconds or longer. Check that the Sound function comes on the Alertmaster console.
AM-DX Press the intercom or door chime button. Check that the Door function comes on at the Alertmaster console.
IN CASE OF DIFFICULTY
If any problem should occur during operation of your Alertmaster AM-AX, AM-BX, or AM-DX accessory, review the list below and your Alertmaster AM-6000 or AM-7000 O perating Instructions. Should the difficulty persist, contact AMERIPHO NE or your authorized dealer for assistance.
SYMPTOM
System does not respond when Alertmaster AM-accessory is tested
Alertmaster console does not respond when Alertmaster AM-accessory is tested.
System activates erratically
CAUSE & REMEDY
Adjust the sensitivity. O r battery needs to be replaced.
The accessory may not be at the right “Channel Setting”. See “Channel Setting” section.
If the System picks up other wireless signals, change channel setting on all components. See “Channel Setting”.
SENSITIVITY ADJUSTMENT
All accessories have been pre-set to their optimum sensitivity in the factory. But, for best results and to suit your application, follow these steps to adjust their sensitivity:
AM-AX & AM-BX Start at HI and if it is activated easily by other sounds, lower the sensitivity.
AM-DX Raise or lower sensitivity until it is consistently activated by door or chime or intercom.
CHANNEL SETTING
The Alertmaster System uses special radio signals to communicate between the console unit and all its accessories. For the accessories to activate the base unit, they all have to be on the same “channel”. A “DIP Switch” is used for channel selection.
Your system and all the accessories have been pre-set in the factory to a standard channel setting. Under normal operating conditions, there is no adjustment necessary.
If your system encounters interference and repeatedly activates by itself for no obvious reasons, it may be triggered by a system nearby in your neighborhood. Change channel switch settings on all components.
- locate the DIP Switches on the under-side of the AM-6000 or the back of the AM-7000 console.
- Change the switch setting by turning all individual switches to a different position.
- Unscrew housing and locate DIP Switch inside of the transmitter.
- Change the switch settings on each of your other accessories (doorbell, Remote Receiver, etc.) to match the new switch setting in the console. All settings must be identical for the system to work.
LIMITED W ARRANTY
Ameriphone warrants the AM-PX/ PXB against any defect in workmanship or material, for a period of one year from the date of purchase.
If the product is defective and returned within 30 days of purchase, the unit will be replaced at the place of purchase at no charge.
If it is returned after 30 days but within one year, Ameriphone will repair or replace it at no charge. In repairing your AM-PX/ PXB, we may use new or reconditioned parts. If we elect to replace your AM-PX/ PXB, we may replace it with a new or reconditioned prod-uct of the same or similar design. Repair or replacement will be warranted for either 90 days or the remaining time on the warranty period, whichever is longer. When in need of warranty repair, please call our customer service department at (800) 874.3005 (voice), 800-772-2889 (TIY). They will help you process your return shipment You must prepay all shipping costs.
Implied warranties, including those of fitness for a particular purpose and merchantabili-ty (unwritten warranty that the product is fit for ordinary use), are limited to one year from date of purchase. We will not pay for loss of time, inconvenience, loss of use of your AM-PXI PXB or property damage caused by your AM-PX/ PXB or its failure to work, or any other incidental or consequential damages. Some states do not allow limitations on how long an implied warranty lasts or the exclusion of incidental or consequential damages, so the above exclusions or imitations may not apply to you.
We suggest you save the original package materials in the event that you need to ship your AM-PXI PXB back. When shipping for warranty repair, include your name, address, phone number, proof of date of purchase and a description of the problem. After repair-ing the product, we will ship it back to you at no cost within the United States.
This warranty does not cover defects resulting from accidents, damage while in transit to our service location, alterations, unauthorized repair, failure to follow instructions, mis-use, use outside the United States or Canada, fire, flood and acts of God.
12082 Western Avenue, Garden Grove, CA 92841
VOICE 800-874-3005 TTY
800-772-2889
FAX 714-897-4703
ameriphonecs@plantronics.com
www.ameriphone.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>