ZONIT Z-Lock Locking Power Cords Instructions
- June 3, 2024
- ZONIT
Table of Contents
ZONIT Z-Lock Locking Power Cords
Instructions
FEMALE END
- Insert cord firmly into device.
- Cord is now locked.
- To release, pull on either of the red tabs and remove cord.
- Cord will detach from device.
MALE END
- Ensure nut is backed out as far as possible.
- Insert cord firmly into device.
- Push and tighten the nut to initial resistance, then add 1/4 to 1/2 turn to secure. (Do not over-tighten).
- Cord is now locked. Visually inspect to be sure connector is fully inserted.
- To release, loosen nut as far as possible.
- Cord will detach from device.
- Align nuts as shown to maximize clearance in ganged receptacles.
Do not connect the male and female ends of the zLock cord to each other. Damage may result. The male plug end should only be inserted into a PDU style recessed receptacle.
Zonit Structured Solutions
- 1790 30th Street, Suite 140, Boulder, CO 80301
- www.zonit.com
© 2017 Zonit Structured Solutions LLC | All Rights Reserved
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>