FEISS COLLECTION FE-PAYNE-1-BATH Payne 1-Light Wall Light Instructions
- June 3, 2024
- FEISS COLLECTION
Table of Contents
FEISS COLLECTION FE-PAYNE-1-BATH Payne 1-Light Wall Light
FE-PAYNE-1-BATH
Please install the fixture onto a sufficiently strong, load bearing surface.
See final page for wiring instructions.
If this product is being installed in a bathroom or a location where the product will be exposed to high levels of moisture, it is suggested that you apply a silicone seal around the back-plate/canopy. (Not supplied).
Before starting the electrical work or connecting your light you will need to switch off your power supply at the fuse box (consumer unit). Either the miniature circuit breaker (MCB) can be turned off for the circuit for your light (it is suggested to apply RED insulating tape over the MCB to prevent it from being accidentally turned on). Or the main switch can be turned off, the circuit fuse removed, and the main switch turned on again to restore power to the rest of the house.
GREEN/YELLOW Earth
BROWN Live
BLUE Neutral
BLUE with brown sleeving Switch wire with sleeving
Live wires can also sometimes be signified by a RED wire
Neutral wires can also sometimes be signified by a white or black wire
CLASS I Luminaires (Earthed) – Connect the brown wire from the luminaire to the supply live wire (red or brown). Connect the blue wire to the supply neutral wire (black or blue). Connect the green/yellow wire to the supply earth wire (green/yellow) or connect the supply earth to the luminaire earth terminal marked:
CLASS II Luminaires (Not earthed) – These luminaires are double insulated and have the symbol:
These fittings do not have to be connected to the supply earth. Make sure that
the basic insulation of the supply wiring cannot contact touchable metal.
Connect the brown wire from the luminaire to the supply live wire (red or
brown). Connect the blue wire to the supply neutral wire (black or blue).
Isolate the supply earth wire.
If silicone sleeving is provided, fit over the supply cable up to the terminal
block or lamp holder, to at least the mounting surface, to protect cable from
heat.
Recycling
Please try to recycle electrical products and components. Check with Local
Authority or Retailer for recycling advice.
Help line +44 1420 82377
IT IS RECOMMENDED THAT LIGHTS ARE INSTALLED BY A QUALIFIED ELECTRICIAN
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>