datamax-oneil Static Brush Installation Guide
- June 3, 2024
- datamax-oneil
Table of Contents
datamax-oneil Static Brush Installation Guide
Installation Instructions
-
Turn ‘Off’ and unplug the printer.
-
Open the cover. Using the illustrations below, locate the area where the Static Brush will be installed.
-
Using a Cotton Swab or cloth, moistened with isopropyl alcohol, gently clean the surface where the Static Brush will be installed.
WARNING
Isopropyl alcohol is a flammable solvent; always take the proper precautions when using this substance. -
Peel the backing from the adhesive strip on the back of the Static Brush and affix the brush to the printer in the location shown in the below illustrations.
Note: The Static brush should be installed so the bristles are as close to the ribbon without actually touching. It may be necessary to install a roll of ribbon in order to properly align the brush to the ribbon.
M-Class Printers
Note: For M-Class printers, the Static Brush must be cut to length in
order to fit properly.
I-Class Printers
H-Class Printers
Documents / Resources
|
datamax-oneil Static
Brush
[pdf] Installation Guide
Static Brush, Brush
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>