REMEZ air RMVC-503 MultiClick Pro Cordless Vacuum Cleaner User Manual

REMEZ air RMVC-503 MultiClick Pro Cordless Vacuum Cleaner User Manual

SAFETY PRECAUTIONS

• Read all safety precautions carefully. Before turning on the vacuum cleaner, make sure that the mains supply voltage matches the voltage indicated on the charger.
• Do not use the vacuum cleaner to clean wet surfaces. The device is not intended for collecting water.
• Do not leave children unattended if they are using the device or are nearby while being used. Do not allow children to play with the vacuum cleaner.
• Do not leave the vacuum cleaner running unattended.
• For the most efficient operation of the device, empty the dust container before usage. When the dust tank is full, the power of the vacuum cleaner is significantly reduced.
• Do not store the appliance near the kitchen stove, in the open sun, etc., as hot air can cause plastic parts to deform.
• Do not cover the intake or exhaust port.
• When disconnecting the plug from the mains, hold it directly by the plug, not by the cable.
• Persons with reduced physical, sensory or mental capabilities (including children) and persons without sufficient experience or knowledge should not use this device unless their actions are controlled by a person responsible for their safety.
• Be sure to disconnect the battery before cleaning or servicing the vacuum cleaner.
• If any faults are found, disconnect the vacuum cleaner from the power source and contact the Service Center.
• To prevent accidents in the event of damage to the power cable, it must be replaced by a specialist of the Service Center.
• Do not immerse the vacuum cleaner in water to clean it. Doing so may cause damage to the vacuum cleaner or cause fire.

Battery Charger

• Do not use the device outdoors or on wet surfaces.
• Unplug the charger from the mains when not in use and before servicing.
• Do not use chargers not supplied by the manufacturer for recharging.
• Do not use the device if the power cord or plug is damaged.
• Do not pull on the cable, do not use it to carry the device, do not allow it to be pinched by a door. Keep the power cord away from hot surfaces and water.
• Do not disassemble or store batteries near sources of ignition, exposure to high temperatures may cause an explosion (storage temperature of batteries is from +10 to +30 degrees).
• Do not try to open the charger yourself. Charger repairs should only be carried out by qualified Service Center technicians.

Using a vertical vacuum cleaner

• Do not use the vacuum cleaner to pick up hard, sharp or flammable objects such as glass,
• Do not use the vacuum cleaner to pick up hard, sharp or flammable objects such as glass, nails, screws, cigarettes, matches, etc.
• Do not use the vacuum cleaner without a filter.
• Do not use the vacuum cleaner without a dust container
• Do not use the vacuum cleaner if the openings are blocked.
• Avoid getting dust, lint, hair, or any other object that might obstruct the flow of air into the openings.
• Do not use the vacuum cleaner to pick up toxic materials (chlorine bleach, ammonia, and other chemicals.).
• Do not use the vacuum cleaner in an enclosed area where the air contains high concentrations of oil paint vapors, solvents, flammable dust, or other explosive or toxic fumes.
• Do not incinerate the appliance, even if it is severely damaged. Batteries may explode in a fire.
• Always switch off the appliance before connecting or disconnecting the motorized brush .

SAFETY RULES FOR USING THE BATTERY

• The device contains a lithium-ion battery, which can only be repaired by Service Center personnel. If the battery does not hold a charge well, it must be replaced. Contact the Service Center to replace the batteries. If necessary, you can purchase an additional battery on the official REMEZair website.
• Handle rechargeable batteries with care. Do not short-circuit the batteries, which could be caused by contact between metal objects and the ends of the batteries. In the event of a short circuit, the temperature of the batteries can rise to a dangerous level and cause severe burns or fire.

ENVIRONMENTAL PROTECTION

In accordance with the current legislation, a defective device must be returned to the Service Center, where it will be safely disposed of.

PRODUCT COMPONENTS

VACUUM CLEANER OPERATION

Use of attachment nozzles

1. The motorized floor brush is suitable for cleaning all kinds of surfaces: floors, carpets, tiles, parquet, etc.
2. The brush nozzle allows you to effectively remove dirt from any surface.
3. Сrevice nozzle for cleaning in hard-to-reach places.
4. Mini power brush for furniture will effectively clean upholstered furniture.

Installing and removing the battery

Align the groove on the battery case and the guide on the vacuum cleaner case and insert it straight (as shown in figure) until it clicks.

Grasp the handle and press the battery release button. While holding down the button, remove the battery from the instrument.

Connection and disconnection of the tube and body

By pressing the button on the body of the device, you can disconnect the tube. To connect the tube and the body, it is also necessary to fix the rod in the desired position until it clicks.

Connection and disconnection of the tube and the motorized floor brush

Removing and installing the dust tank

To detach and install the dust tank, press the corresponding button and turn the tank in the direction indicated by the arrow.

Turning on the appliance

After pressing the power button, the device will start working.

When the button is pressed again, the device stops working.

Switch between three modes

Pressing the TURBO button sequentially switches the operating modes of the device:

When pressed, the corresponding speed indicator lights up.

Charging the battery

If the battery level indicator is at its lowest and is blinking, the battery needs to be charged.

1. The battery of the cordless vacuum cleaner can be charged in two ways:
   • During charging, install the vacuum cleaner correctly in the hanger and connect the power adapter to the battery.
   • The battery can be removed from the device and charged via the AC adapter at any convenient location.
2. The plug of the power adapter is inserted into the corresponding hole in the battery.
3. The battery charging time is 4-5 hours. When charging is in progress, the battery indicator flashes. After the battery is fully charged, the indicator lights up continuously without blinking.

Note:
Use the supplied adapter to charge the battery.
Please charge the battery fully before using it for the first time.
You cannot use the vacuum cleaner while charging.
Warning! Do not leave the battery unattended while charging; after the battery is fully charged, disconnect it from the charger.
When charging the battery separately, the numbers 1, 2, 3 located on the display flash.

Affixing the device

1. Fasten the bracket to the wall using the supplied screws and dowels.
2. Fix the vacuum cleaner head in the hanger.
3. If necessary, fix the attachments to the hanger.

Using attachments for hard-to-reach places

• Brush nozzle
• Crevice nozzle
• Mini power brush for furniture

1. Select the desired hard-to-reach attachment and attach it directly to the suction port of the dust container.
2. To increase the cleaning space, if necessary, fix the desired accessory to the metal bar.

Easy cleaning of the dust tank

After each cleaning, clean the tank of dirt and dust.
Press the upper end of the catch at the bottom of the dust tank, and the bottom of the dust tank will automatically open.
Collected dirt should not exceed the MAX mark.

Cleaning the vacuum cleaner

After using the vacuum cleaner, it is recommended to clean the dust tank and clean the brush if it gets clogged. A full dust tank will significantly reduce the efficiency of the vacuum cleaner.

1. Disconnect the dust container from the case of the vacuum cleaner, then sequentially remove all filtration elements from it HEPA filter, cyclonic filter, main filter.
2. Rinse filtration elements from it HEPA filter, cyclonic filter and main filter under running water and dry at room temperature. Use the optional HEPA filter included in the kit. You can purchase an additional filter if necessary.
3. Place the filtration system elements back into the dust tank. When installing the pre-filter, align the grooves of the body and the filter. Install the HEPA-filter on the cyclonic filter.
4. Secure the container to the instrument case by turning it clockwise as indicated on the container.

Cleaning the motorized floor brush

1. Remove the roller brush retainer from the underside of the motorized accessory, then remove the roller brush.
2. Remove hair and other debris from the roller brush and clean the brush inlet.
3. Place the clean brush back into the motorized accessory and reinstall the retaining parts.

Note:

• If cloth or other foreign matter gets into the vacuum cleaner and blocks the rotating brush, the motorized nozzle will stop working to avoid damaging the motor of the appliance. Turn off the vacuum cleaner, clean the brush from any foreign objects, and then turn on the appliance again.
• If the attachment does not work after cleaning, switch the vacuum cleaner off and on again.
• When cleaning the brush, be careful not to pinch your fingers where the brush is attached.

Attention

• To avoid injury, do not touch the inside of the rotating brush head during operation.
• When assembling the case of the vacuum cleaner, be careful not to pinch your fingers or hands at the attachment point.
• Do not use a vacuum cleaner to clean surfaces that can be scratched (TV screens, monitors, etc.).

TROUBLESHOOTING

Before contacting the REMEZair Service Center, please read the following descriptions of the problems and their solutions.

The vacuum cleaner does not work!

• Check the battery level and charge if necessary.
• Make sure the unit is turned on. If it is off, press the power button to turn it on.
• Make sure the dust tank or attachment is not clogged.
• If the device has not been used for a long time, charge the battery.

The suction power is suddenly reduced, the vibration of the vacuum cleaner is heard!

• Make sure the dust tank, nozzle or shaft is not clogged with foreign objects.Remove them if necessary.
• Check if the dust tank is full. If the level of collected dust in the container exceeds the MAX mark, clean it.
• Make sure the filtration system of the vacuum cleaner is not dirty. Clean it if necessary.
• Check the battery level and charge it if necessary.
• Make sure the voltage supplied to the charger is within specifications. The motorized floor brush does not work!
• If the roller brush inside the attachment does not work, turn off the appliance and make sure it is not blocked by dirt. Remove dirt if necessary.

An unpleasant smell is emitted from the air outlet of the vacuum cleaner!

• Regularly, after each cleaning, clean the dust tank and filters. If you use the vacuum cleaner frequently, dirt in the dust container or dust on the filter may cause an unpleasant smell. One replaceable HEPA filter is included with the device. Additional HEPA filters can be purchased on the official REMEZair website if required.
• After cleaning the appliance, press and hold the Turbo button for about 10 seconds to remove fine dust particles from the suction element.

THIS DEVICE IS INTENDED FOR DOMESTIC USE ONLY

SPECIFICATIONS

ООО «Ромати», Rossiya, 121596, г.Moskva, ul.Gorbunova,d.2,str.3, of.А204

http://www.remezair.com

Phone: 8 (495) 488-72-57
[info@remezair.com](info@remezair.com)
<http://www.remezair.com>

References

• REMEZ air официальный сайт компании

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>