CSA-IOT Co002 Connecte Smart Thermostat User Manual

June 3, 2024
CSA-IOT

CSA-IOT Co002 Connecte Smart Thermostat User Manual
CSA-IOT Co002 Connecte Smart Thermostat

Description of screen indicators

  • a. ZigBee icon. The ZigBee icon will flash when the thermostat searches for networks and lights up when connected.
  • b. Day (1-7, Monday-Sunday) and time. This is set automatically after a short time whenconnected to the ZigBee gateway.
  • c. Home and Away mode.
  • d. Heating on / off indicator. If the thermostat heats the floor, the lines will move to the right. If maximum guard is used, the lines flash if the temperature limit is  exceeded.
  • e. Indicator flashes when open window is detected.
  • f. Manual / Auto indicator
  • g. Indicates that the temperature is set.
  • h. Indicator for active child lock / button lock

: On/Off button : Inc. temp. : Lower temp. : Mode button

Functions

Button Short press Long press
Confirm/go back Turn ON/OFF
Change between air and floor sensor (air and floor mode)


| Temperature increase| Enter menu
| | Open advanced settings
| Temperature decrease| Start ZigBee pairing
| | Lock/Unlock
| Change between home and away mode| Display date in MM/DD format

To control the thermostat remotely it must be added to a ZigBee gateway

  1. Start the process of adding new devices to your ZigBee gateway and follow the instructions.
  2. To put the thermostat in pairing mode: Long press until the ZigBee icon flashes
  3. Continue the process of adding new devices to the app.

Advanced settings

When the thermostat is on, press  and hold and (5s) simultaneously to open advanced settings.

  • You can change settings with  or
  • Press to select the settings and proceed.
  • To save the changes and exit advanced settings, press
  1. Sensor type
    00: Air sensor / Internal
    01: Floor sensor / External
    02: Max guard / regulator on
    air temperature and limiter
    with floor sensor

  2. Floor sensor type / External
    0: 10 kOhm
    1: 12 kOhm
    2: 15 kOhm
    3: 47 kOhm

  3. Max Guarding Temperature
    This must be set in the thermostat.
    20-95 ° C, Standard is 27 ° C, ‘-‘ No limit.

  4. Turn
    1-9 ° C, Standard is 2 ° C

  5. Calibration
    -9 to + 9 ° C, Standard is 0 ° C

  6. Highest set point
    35-90 ° C, Standard is 35 ° C

  7. Lowest setpoint
    0-30 ° C, Standard is 5 ° C

  8. Home mode setpoint
    The standard is 22 ° C

  9. Setpoint for away mode
    The default is 15 ° C

  10. Brightness in sleep mode
    1-10, default is 1

  11. Open window detection
    0 = Disabled 1 = Active

  12. Restart the system
    Press + or – to change ‘-‘ to ‘==’ and wait for 5s

  13. Reset to factory settings
    Press + or – to change ‘-‘ to ‘==’ and wait for 5s

Electrical data

  • Power: 230 V / 50 Hz
  • Circuit breaker: Max 16 A
  • Maximum load: 3600 W
  • 1-pole electronic relay
  • Internal power supply with galvanic isloation
  • Do not use self-regulating heating cable
  • Do not use for contactor control

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals