TRUPER DES-45M Gas Multi Tool Instruction Manual
- September 25, 2024
- TRUPER
Table of Contents
**TRUPER DES-45M Gas Multi Tool Instruction Manual
**
CAUTION
To gain the best performance of the tool, prolong the duty life, make the Warranty valid if necessary, and to avoid hazards of fatal injuries please read and understand this Manual before using the tool.
Keep this manual for future references.
The illustrations in this manual are for reference only. They might be different from the real tool.
Recommendations for use and care
Use gasoline mixed with 2-STROKE ENGINE OIL. Incorrect mixing can cause serious engine damage!
Do not use fuel mix older than 15 days.
ALWAYS operate the machine at MAXIMUM POWER with the trigger FULLY ENGAGED.
LUBRICATE as appropriate for the accessory being used.
Perform REGULAR MAINTENANCE on your machine (page 19).
Technical data
Fuel requirements
- The gas brush cutter runs with an air-cooled two-cycle engine and uses a mix of unleaded gasoline and high quality, self-mixing motor oil with fuel stabilizer specified for air-cooled -2 stroke motor.
- The motor is certified to run with unleaded gasoline for vehicles having an octane index of 87 ([R+M]/2) or higher.
- Do not use any type of gasoline and oil mix sold in Service stations, especially, used in motorcycles.
- Do not use motor oil for self-propulsion, or two-cycle oil outboard motor.
- The ratio for the mix shall be 50 parts gasoline per 1 part oil (50:1 Ratio). Prepare the mix in an approved fuel container.
Always mix thoroughly before pouring it into the motor fuel tank.
CAUTION Do not use a fuel mix that has been sored longer than 15 days.
Mix small quantities.
WARNING Never smoke near the fuel or where fuel is being supplied, or in
the oil-gasoline mix preparing site or
when operating the brush trimmer.
WARNING Trying to start the gas brushcutter without mixing oil into the
fuel will cause a faulty motor
Use ACES-2,ACES-5 or ACES-20 TRUPER EXPERT oil caps** to measure the mix.
Mix 4 capfuls oil per each gasoline liter.
A wrong mix may cause the gas brush cutter to throw a rod causing expensive repairs!
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>