Sphere 12 Channel Receiver Instruction Manual
- September 19, 2024
- sphere
Table of Contents
Sphere 12 Channel Receiver
Initial Setup
Please also ensure that your 12 channel receiver is powered up correctly. You can confirm this by switching on and off the lights inside your RV with the wireless lighting switches.
To control your 12 channel receiver Wireless Switch you do not require an active internet connection. Please follow the steps mentioned in the Programming Wireless Switches section of this document.
Programming Wireless Switches
To program wireless switches to the 12 channel receiver, please follow the below steps:
-
Unscrew the plastic housing covering the dip switches
-
Locate the channel or channels which you wish to program a wireless switch to.
-
Move the desired channel(s) dip switch position to “ON”
-
Press and hold the wireless switch button down for ~6 seconds until both the LED on the wireless switch and LED inside the 12 channel receiver housing flash Orange
-
Move all channel dip switches back to “OFF” position
Your wireless switch is now programmed to the selected channel(s)
Please note, the Master OFF buttons need to be programmed to all channels for full control.
To delete a wireless switch from a certain channel:
- Locate the channel or channels which you wish to delete a wireless switch from.
- Move the desired channel(s) dip switch position to “ON”
- Press and hold the wireless switch button down for ~6 seconds until both the LED on the wireless switch and LED inside the 12 channel receiver housing flash Red
- Move all channel dip switches back to “OFF” position
Your wireless switch has now been deleted from the selected channel(s)
Customer Support
More information https://www.caravansplus.com.au
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>